- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Pull off the wiper arms when the motor has turned off and the wipers at rest. Realign the arms in the position desired and do a test with a mist of water on the glass. The gear alignment is critical to the way the arm rests when in operation and when at rest.
loosen the nut at the bottom of the blades so that the wiper motor will work without moving the blades. cycle the wipers and allow the motor to come to the rest position. Fit the blades and tension the nut. Pull the arms off the windscreen and cycle the wiper motor to run until it stops put the wipers back on the screen and see where they are. IF parked properly then OK but if any where then replace the wiper motor as the sequencing gear inside is out of sync with the wiper action.
With ya'lls perty white heavy snow,it made your wipers get unaligned,you will have to remove and reset.It's not good to remove snow from wipers when windshield is loaded,get a scraper or blower and go at it.Wish we got snow.
Open the rear window and push the arm past its usual position against the window. It may restore the the tension. However, You likely need a new wiper arm, you could also try lubricating the pivot point.
Put the right side wiper on only. Turn on wipers. When the wiper moves all the way to the left and starts to go back to the right turn off the ignition with the wiper switch still on. Remove the right wiper arm and install the left wiper arm in the far left of the wiper movement. Turn on ignition and allow the left wiper to go all the way back to it's rest location at the bottom of the windshield. Turn off ignition and install the right side wiper arm. This will give you a start to properly set the wiper arms.
This is a commoon problem with what is called the "Park pawl stop". The tab is most likely bent and needs to be re-aligned, then the wipers need to be re-timed. This re-timing can be a little difficult, although the re-aligning of the tab is failry simple.
The problem could be a bent parking pall bracket. This is usually caused when you wipe snow from windshield using the wipers instead of brushing off. You need to remove both wipers and the cover from the drivers side. Remove the cover over the wiper motor assembly (held by a plastic button). On the right side of the wiper mechanism is a small tab (part of the wiper bracket). This tab needs to be straight for the wiper park pall to rest against.Carefully hammer this tab straight (or you may have to replace bracket, big job) Then cycle the wiper and you will see the assembly return to park position. Re-install all parts in reverse order.
Hope this works for you.