Question about 2004 Cadillac Escalade
Brake lights work but third brake light out replaced with new is there a seperate fuse to this light
Couple of things....#1..the 3rd brake light is on a different wiring circuit then the lower brake lamps. #2...The 3rd lamp shares the same fuse as the trailer hitch wiring. So if you ever pull a trailer, it's easy to blow the fuse. #3...the dash was changed in 2003...in 2002 the fuse is in the underhood fuse block....2003 it is in the left side dashboard fuse block. #4...If all else fails...rebuilt lamps are available. See http://www.ledfix.com
Posted on Feb 01, 2012
SOURCE: 1998 gmc sierra brake lights
did u check that they not burn?if not you should Check the wires going into the steering column if you don't have separate turn signal lights and brake lights because if they use the same bulb then the turn signal may be bad. If I remember correctly that particular car doesn't work this way, but I include it just in case.
Posted on Jun 29, 2008
The chevys with red brake lights and turn signals do two things and I've fixeds alot of them. Looking at the tail lights with the hazard flashers on. both sides flash with nothingeles on? Or are the hazards yellow? if they're red and the third eye does work the turn signal switch is possible problem but it doesn't let the blubs and the circuit boards in the taillights out as they can fail and do some really bad stories the wires for the brakes and the turns and the hazards are the same ones and if the turns look right and the hazards look right then the turn signal switch transmites the turn too as this doesn't work part of your story can't be true
Posted on Aug 19, 2009
I had the same problem and found out that both light bulb sockets had corroded/burned contacts. After cleaning and applying dielectric grease, they worked perfect again.
Posted on Dec 17, 2009
SOURCE: third brake light doesn't work
I had the same problem. It turns out that the resistor was burnt, as this is a LED light strip and not a single bulb. If you are handy and want to save $$$$ you can get a replacement resistor through a parts store such as Radio Shack and solder it into the board. I did this and it works just fine
Posted on Feb 02, 2010
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
Feb 12, 2016 | Cars & Trucks
Aug 28, 2011 | 2002 Ford SVT Focus
Aug 23, 2011 | GMC C1500 Cars & Trucks
Jan 28, 2011 | 1992 Oldsmobile Bravada
Jun 25, 2010 | 2001 GMC Jimmy
Jan 11, 2010 | 2005 Chevrolet Silverado 2500HD 2WD
Dec 22, 2009 | Chevrolet S 10 Cars & Trucks
Apr 09, 2009 | 1995 Chevrolet Astro
891 people viewed this question
Usually answered in minutes!