Question about 1999 Mitsubishi Galant

1 Answer

Car alarm not working

I change the battery on my 99 galant now the factory alarm is not working..how do i reset it

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 52 Answers

Usually all you need to do is point the remote at the car and press and hold both the lock and unlock buttons for 8-10 seconds.

Posted on Mar 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i reset a 99 explorer factory alarm


you need the remote control to do it if you disconnected the battery and then reconnected it when the alarm goes off you have to press the disarm button otherwise the alarm goes into theft mode and will not start buy the remote control if you need it now and you can program it into the system once in and the pats system has it stored you will then be able to start your car again good luck

Feb 17, 2015 | 1999 Ford Explorer

1 Answer

Security system reset


You can usually reset the alarm by unlocking the car using the key in the drivers door.if that doesn't work the alarm module is usually in the drivers kick panel area and unpluging it will usually disarm.all this if its a factory system. If aftermarket just look for the alarm brain and unplug it till you can get it to a stereo shop.

Feb 13, 2014 | 1995 Mitsubishi Galant

1 Answer

Changed my car battery on my 99 Avenger and the horn goes off and car won't start.


It sounds like you have an alarm system that is disabling the ignition. You need to reset the alarm system.

Apr 21, 2012 | Dodge Avenger Cars & Trucks

1 Answer

How do you reset the alarm system after changing a battery in a 1998 toyoat 4runner


factory alarms do not need to be reset.. if a problem cycle key in drivers door lock then unlock a few times// that manually sets and deactivates factory alarm

Dec 08, 2009 | 1998 Toyota 4Runner

1 Answer

How do I disarm a 1995 Mitsubishi Galant alarm


to re set i think u remove wires from battwey put live wires to negative for about a minute the then replace

Aug 06, 2009 | 1999 Mitsubishi Galant

1 Answer

How do i reset the factory alarm


if you unplug the battery this can reset it.......

but if that does not work....then this is what you should do...

Make sure the drivers front(left front) door is closed and you have your car keys.
Insert your door key into the drivers door and turn it to the locked position two times.
Then turn the key to the unlock position twice.
The alarm should be disarmed, now.
there could be other way of doing it but this works on most cars....



**also you must know that but in some cars the tranny needs the battery as the tranny needs to learn how to shift right.......so in some cars like the 2002 expedition if you unplug the battery the tranny will forget how to shift right again...and so...you might experience slight changes in the way you car runs...it could take longer for it to shift.........BUT NOT TO WORRY.....
good luck man!!

May 14, 2009 | 1994 Jeep Grand Cherokee

1 Answer

Change battery on 99 galant


usually all you need to do is hold the lock and unlock buttons at the same time for about 8-10 seconds will pointing at the car.

Feb 02, 2009 | 1999 Mitsubishi Galant

1 Answer

Mitsubishi Magna GLX 1993 jumpstarting sets off alarm!


Is the alarm factory fitted, cheap, or a top of the range.
the factory alarm you can pull the cable of the horn untill you get the car started.
there are some alarms that go off when there is a voltage change, and some will keep going for a couple of minutes if the battery is dead flat untill there is power to equilze the power abit,
and some alarms have a key over ride in the siren.
if its a cheap alarm take the battery of and charge it,(the alarm will cut out as soon as the battery is disconnected.
~dont jump start from a dead flat battery, as it can cause a lot more problems with the electrics, leave another car running with the jump leads on for at least 5 min first.~
Rich

Dec 10, 2008 | 1993 Mitsubishi Galant

1 Answer

99 galant check engine light


temporarly disconnected the battery.

Oct 15, 2008 | 1993 Mitsubishi Galant

Not finding what you are looking for?
1999 Mitsubishi Galant Logo

356 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...