Question about 2001 Chevrolet Tahoe

1 Answer

Power window has fallen down.

It seems the motor would bring it down but not up.  I can slide it up but it feels like it is off track. can anyone help?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 840 Answers

Yes you need to take the trim panel off and check the run channel or glass channel /please rate my response if you need step by step instr.ket me know! please rate my response thank you very much

Posted on Feb 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Does anyone have a picture diagram of the reardoor window tracks and hardware /2002 saturn L300


Your power window motor is shot , buy another one, it takes three or four bolts to remove it. The window slides on the track.

Apr 16, 2015 | 2002 Saturn L-Series

1 Answer

VW bettle 2000 power window fell down power motor works but won't lift window drivers side


You may have a number of problems, all can be answered by removing the door pnl and inspecting. The window may have fallen out of the track, the window motor may have fallen out of the regulator, the motor's drive system may have stripped or broken, the regulator itself may have failed or broken or the window is no longer attached to the regulator. Pull the pnl and start inspecting. Good luck!

Jan 17, 2012 | Cars & Trucks

2 Answers

How do you get power window back in it's track, rear upper section of the window has fallen forward.


If you want to do this you need to remove the inner door panel( and maybe a weather barrier). be aware if you have any power options with switches on the door panel they must be disconnected before you attempt door panel removal.as soon as you remove the door panel(usually two or three screws and a dozen easily breakable plastic clips holding it in place) you will be able to see the window lift mechanism. if the window has not fallen completely off track you will be able to see how it is held by the "lift cradle" carefully without letting the window fall down into the door place the window back into its track"cradle" and loosely tighten the fasteners. and reconnect the window crank or window switch temporarily to slowly lift and lower the window while supporting it with your hand (to be sure it doesn't fall off its track while testing it) check if the window is tracking properly. if if seems to slide up and down appropriately and lands into the window seal appropriately then lower the window to a place where you can snug down the window retainers not too tight so as not to break the glass. and replace the door panel. after all switches or mechanisms are replaced test it again slowly to check for appropriate function and if you are satisfied pat yourself on the back for a job well done. i hope this helps

Jan 08, 2011 | 1994 GMC Jimmy

1 Answer

Rear power window has fallen off track on 2004 jeepcan the door panel be removed and replaced without special tools


Yes. But it is not as simple as putting the window back on track. Most new vehicles use a different type of regulator (not the old pinion and rack type gear. Most use a small motor that is attached to cables that raise and lower the window. Most often these cables break and the window falls. Pull the inner door panel off and you can verify. If it is the regulator, check out Amazon. Seem to have the best prices and warrantees. Good luck!

May 20, 2010 | Cars & Trucks

1 Answer

How to replace a motor mount on a 1999 passat


I went to roll my left rear window in my 99 Passat and i heard something drop. the window wont go down now. but the motor works cause i can hear it going up and down. And when i bring it down it wont take the window with it. It seem as if the peice that hold the window to the track has fallen off . Anyone have idea of what this part could be??

Thanks

May 11, 2010 | 1999 Volkswagen Passat

1 Answer

Need to access power window motor . window won't roll up.


Remove inner door trim panel. Remove plastic insulation. Wedge or duct tape your window. So when you separate the window and its tracks, It wont slide down and break. Remove window regulator and tracks
then start separating the window motor from the tracks.
Test for power and ground first and the connector and the switch. Before you condemn the motor.

Nov 30, 2009 | 2000 Chevrolet Silverado

1 Answer

02 tahoe, left rear passenger window has fallen down.


it has jumped off track to fix this you need to take the door panel off and put it back on track

Apr 11, 2009 | 2002 Chevrolet Tahoe

2 Answers

Driver window will not drive up or down.


if the motor runs, than it doesnt have to be replaced, your window is not secured to the track. those plastic pieces are what holds your window on the track. Replace those, you can get them for less than 20 bucks at the parts store

Dec 06, 2008 | 1999 Mazda Protege

Not finding what you are looking for?
2001 Chevrolet Tahoe Logo

Related Topics:

113 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...