Question about 2006 Volkswagen Jetta

1 Answer

Driver side mirro turn signal is out

I need to change it and was hoping for a DIY manual on it.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 840 Answers

You need to take off the cover of the mirror it should just pop off use a small flat head screw driver and find where its attached then you can change the light Please rate my response thank you very much

Posted on Feb 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the flasher located at?


Two FLASHER applicatiosn there:
Hazard flasher: Front seating area, driver side, under dash, driver side of steering column, mounted in convenience center

Turn signal: Front seating area, driver side, under dash, driver side of steering column, mounted in convenience center

If you need additional details or some repair manual sections, just send us a new comment.

Hope this helps (remember to rate and comment this answer).

Aug 29, 2011 | 1996 Jeep Grand Cherokee

1 Answer

Where is the flasher relay for a 97 jeep grand Cherokee?


Two FLASHER applicatiosn there:
Hazard flasher: Front seating area, driver side, under dash, driver side of steering column, mounted in convenience center

Turn signal: Front seating area, driver side, under dash, driver side of steering column, mounted in convenience center

If you need additional details or some repair manual sections, just send us a new comment.

Hope this helps (remember to rate and comment this answer).

Aug 19, 2011 | 1997 Jeep Grand Cherokee

1 Answer

Location of 1994 cavalier turn signal flasher unit


The Flasher is located:
* Front seating area, driver side, under dash, mounted on passenger side of steering column
Application: Turn signal

* Front seating area, driver side, under dash, mounted on driver side of steering column
Application: Hazard flasher

Hope helps (remember toi rate and comment this).

Oct 09, 2010 | 1994 Chevrolet Cavalier

1 Answer

1986 Grand Marquis..........can not find the location of the fuse panel to change the signal flashers


1986 Mercury Grand Marquis 5.0L FI 8cyl. the Flasher is located in front seating area, driver side, under dash, driver side of steering column, mounted in fuse panel (turn signal) and front seating area, driver side, under dash, driver side of steering column, mounted in rear of fuse block (Hazard flasher).

Hope helps (remember to rate and comment this).

Sep 23, 2010 | Mercury Grand Marquis Cars & Trucks

2 Answers

Need to replace signal light flasher can not find old one


The turn signal flasher and hazard units are usually located located under the dash either to the left or right of the steering column on most models:
  1. Remove the turn signal flasher unit or hazard unit by pulling them up from the electrical connection.
  2. To install, push the unit(s) into the electrical connector.
Also, I suggest check your repair manual in this link: Jeep ZJ-Secc-8W-Wiring-Diagrams

Hope helps (remember rated this).

Jul 02, 2010 | 1994 Jeep Grand Cherokee

1 Answer

Replace turn signal flasher. where is it located?


Underdash, in the driver side; review the Repair Manual ZJ-Secc-8W-Wiring-Diagrams (page 8, fig. 13)

I really hope helped with this (remember rated this help). Good luck.


Nov 05, 2009 | 1993 Jeep Grand Cherokee

1 Answer

Driver side mirror loose how do i tighten it


pry loose inside corner trin panel.The adjuster is held into the trim panel with a small allen screw,loosen this to remove trim panel from adjustor.There are 3 10mm nuts attaching mirro to door.Most likey though you have a broken post that is broken off mirror.Very common for them to break.hope this helps

May 20, 2009 | 1999 Saturn SC

1 Answer

Signal light bulb change/who and where


  1. From under front wheelhouse, remove access cover behind park and turn signal lamp
  2. Through access hole in wheelhouse, rotate park and turn signal socket counterclockwise one quarter turn.
    1. Pull socket from back of lamp.
    2. Pull bulb from socket. INSTALLATION
      1. Align key on bulb base to groove in socket and insert bulb into socket.
      2. Through access hole in wheelhouse, insert socket into back of lamp.
      3. Rotate park and turn signal socket clockwise one quarter turn.
      4. Install access cover and verify lamp operation.
Hope this helps with your prob

Mar 27, 2009 | 1998 Plymouth Voyager

2 Answers

Driver side mirro is hot


it is a heated mirror. usually comes on with defroster setting

Dec 31, 2008 | 2001 Lexus IS 300

2 Answers

Where do I install the electronic flasher relay for the turn signals?


If the turn lights come on and don't flash, like mine did, I found the flasher behind the ashtray.If you can't reach it,there are only 4 screws holding the bracket (1/4 in.nut driver) that holds the ashtray.

Oct 27, 2008 | 1993 Oldsmobile Cutlass Ciera

Not finding what you are looking for?
2006 Volkswagen Jetta Logo

363 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

yadayada
yadayada

Level 3 Expert

60792 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...