Question about 2005 Chrysler Crossfire

1 Answer

The Chrysler Crossfire is a nice "looking" vehicle but I've had an issues that my engine would shutdown without warning. The car would restart upwards to about 2 hours later but would shutdown again several miles later. Took it to the dealership THREE times and they have not been able to sort it out. i am now unable to use the car.

Posted by on

  • garydaly Feb 18, 2009

    Exact same problem, any chance you found a fix?

  • perk103 Mar 19, 2009

    i also have a 2004 crossfire that will shut down while driving it. Dealer has no idea what the prolem is. I now don't want to drive this car. any solutions?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

It is a bad solder joint in the RCM (Relay Control Module). Have the dealer replace the module and you should be fine. This is a known problem.

Posted on Dec 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Whats the codes p0685 an p0688 on a 2004 chrysler pacifica mean


P0685 CHRYSLER - Auto Shutdown Relay Control Circuit Failure

Short or open in Auto Shutdown (ASD) relay circuit
Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
Possible Causes
- ASD relay circuit is open or shorted
- Failed Auto Shutdown relay
- Failed ECM
Tech Notes
Check all the ECM fuses, if the fuses are OK try replacing the ASD relay.

P0688 CHRYSLER - Auto Shutdown Relay Control Circuit Low

The Front Control Module (FCM) has detected the supply voltage below an acceptable value
Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
Possible Causes
- ASD relay circuit is open or shorted
- Failed Auto Shutdown relay
- Failed ECM
Tech Notes
Check all the ECM fuses, if the fuses are OK try replacing the ASD relay.

Dec 29, 2014 | 2004 Chrysler Pacifica

1 Answer

Can the 2005 Chrysler Crossfire chirp the siren on remote door lock?


yes you can disable this see the local auto leck buy or the dealer

Dec 04, 2014 | 2005 Chrysler Crossfire

1 Answer

Chrysler crossfire wont start


I fail to see to see a question there

You have no motor shown
You only say it won't start

For all we know, it has been to a shop
& the problem solved by now

Electrical Issue-your asking,your guessing,
we're to guess? Really! Without a car to test
How's that work?

If we were in 1950, it would be a little more complicated
to diagnose vehicle issues back then, than what you provided

Provide details

What testing has been done?
Battery any good?
Got spark?
Got fuel pressure to motor?

Even open the hood?

Jul 15, 2014 | 2005 Chrysler Crossfire

3 Answers

2004 crossfire engine dies at speed


Hello Paul, You stated your crossfire stalls and the usually restarts. It could be several things that cause this... If the check engine light is on, have it scanned to determine what caused it to come on - It sounds like you are having an intermittent crankshaft position sensor failure. I hope this information is helpful...Happy Holidays.

11_23_2011_10_52_42_pm.jpg

Nov 23, 2011 | 2004 Chrysler Crossfire

2 Answers

My 2004 crossfire has done this twice in the last six weeks, and its dangerous as it does it when your driving! Engine just cuts out, then restarts as per normal around 20mins later. Does anyone know...


Check to see if the engine is running hot. This will happen when the engine runs hot. After it has cooled down, then it starts back up until it runs too hot again. If that's the case it could be the thermostat.

Nov 28, 2010 | 2004 Chrysler Crossfire

2 Answers

05 Chrysler Crossfire Convertible top


Try using urethane sealant to redo the seal between the top and the glass.
I have a VW convertible that had the same problem. The sealant comes in a tube that you use in a caulk gun. Made by 3M and I purchased it from Advance Auto. About 18 bucks.

Jun 02, 2009 | 2007 Chrysler Crossfire Convertible

2 Answers

Chrysler crossfire engine always stall


I have an excellent mechanic at my dealership.
I ran into the problem your are descrbing. Thought it was a fluke but when It got worse took it to the dealership my mechanic diagnosed it as an intermittant failure of the Crankshaft Sensor.

Feb 02, 2009 | 2004 Chrysler Crossfire

1 Answer

F350 super duty,engine cuts out without warning


Check to see if your truck was recalled for a faulty cam shaft sensor. Some sensors develop hair line cracks which allow contaminants to get in and the sensor becomes intermittent. The symptoms can include sudden shutdown of the engine so a recall was issued.

Jun 25, 2008 | 2000 Ford F350 Super Duty Super Cab

Not finding what you are looking for?
2005 Chrysler Crossfire Logo

Related Topics:

598 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...