Re: 1993 Eurovan - how do you access the fuel pump?
I think you have to remove the driver's seat. There should be a round plate that opens right above the gas tank to allow access into the tank. Otherwise you can just drop the tank but the wiring is pretty short and the tank had better be empty. The access plate is far easier.
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
under passengerside of dash board lay down lok against side wall or pull carpet BACK SHOULD BE RIGHT THERE BETTER YET GO TO AUTOZONE LOOK IN INDEX OF THE BOOK FOR FEUL PUMP SWITCH IF BOOK DONT SAY THEN THERE AINT ONE PUT BOOK BACK AFTER YOU FOUND WAT U WERE LOOKN FOR
Very possible. The code for the fuel cap is probably one of the codes for a pressure leak in the gas tank vent system. If it was not smelling before the brake repair, I would take it back to the shop that did the work.
You should be able to access the ful pump thru the back flor of the montero. Start by removing the trim piece at the back of the Montero, this is the piece that holds the carpet down atthe back of the truck. Fold the back seat forward, now carefully pull up on the carpet starting from the back. Just before the rear axel you will see an access plate with, I believe, six bolts holding it down, remove and "bingo", you will see the access for the fuel pump and sending unit.
In the trunk behind the seat, pull back the carpet. there is an access panel in floor. take that off, and you have direct access to the pump assembly, disconect the three hoses and the pigtail, take off the lock ring and pull it strait up. you can only buy the whole assembly so its just swapping them out and putting everything back together.
pull the back seat up theres an access panel on the right side. pull the carpet towards the front on the right side, youll find an access panel remove panel youll need a special spanner wrench to get the cap off, but thats the fuel pump right there.
hi there if you remove the cam pully wich drives the diesel pump you will see a key way in the end of the cam turn the engine untill the key way is flat ( i use a streight edge in the keyway and turn until it is level with the top of the cylinder head ROCKER COVER REMOVED once this is aligned up there is a mark o the back of the diesel pump pully thiss aligns up with a groove between two castings on the side of the pump at the front of the engine once all these are aligned up you can put on the belt ( it may ot start right away this wil be due to needing to bleed up the fuel ONLY IF PUMP BEEN REMOVED and bleeding up the fuel can be a right pain. hope thos helps ben
it is in the trunk on the left hand side, pull away the trunk carpet on left side and you will see a hole with a top and bottom screw remove the screws and pull the relay out threw the hole, then disconect the wiring connector When you plug the relay back in turn on key you should here the pump run for a few seconds if it does not then replace the relay ,or the pump.