Question about 1992 Oldsmobile Cutlass

1 Answer

94 olds door locks

94 cuttlas auto door locks some time don't work or un lock,i changed the relay that did not fix.work 8 out of 10 times pushing button,when it stopes working i wait a minuite,then here click sound in the back seat area,then they work again?any idea?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 840 Answers

Its not the relay its the lock actuator that needs to replaced/ Please rate my response thank you very much

Posted on Feb 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Unlocking door


change your centrol locking relay.

Apr 02, 2014 | 2005 Ford Freestar

1 Answer

Saturn ion door


on the far right is where the location of the door lock relay.
this could be the problem however there is also in the same area a door lock controler.
could be one or the other ,most relays are the same in a car.some times you can switch places with one relay with another relay in the same general area.you might have to drop down the glove box to access these relays or controler.
because of the clicking sound my bet is on the relay, most cost about ten bucks at any auto parts shop.
good luck,Gary

Oct 27, 2013 | Cars & Trucks

1 Answer

94 chevy lumina apv door will not open most of the time


since it is the drivers front door it could be the outside door handle , the rod that goes from the handle to the lock asbly or the lock asbly its self take the door trim panel off and then loos inside the door and latch the door with the door open. open the door with the outside door handle and watch the rod and the lever that the rod is pushing down the lever might not be pushing the lever down far enough to release the lock. If the lock does not open try pushing down on the lever and see if the lock releases if it does ck the outside door handle for cracks along the hinges of the handle I have found that most of the time that it is the outside door handle cracked and the rod is not moving the lever far enough to release the lock.

Feb 20, 2010 | 1994 Chevrolet Lumina APV

1 Answer

Starts fine but when switched off will not start for 10 mins or so, cranks over but does not fire[94 4.0 jeep cherokee]


You are probably unaware that your jeep has an aftermarket keyless entry system....Try this....roll down the drivers window....push the power door lock......get out/close the door...and attempt to open the door as u normally would.......it should be locked...... use your key to unlock the door....get in.....insert the key into the ignition and turn it to on...((((DON"T TRY 2 START IT UN TILL THE WARNING BELL STOPS DINGING & ALL THE DASH WARNING LIGHTS ARE OUT)))...........usually 5 dinging sounds.......at any rate just wait untill the sounds stops and fire up your jeep.....i hope this works for ya.....good luck

Aug 03, 2009 | 1994 Jeep Cherokee Country

1 Answer

Remote door entry not working


could be that the remote lost memory during battery change may need to reprogram

Apr 28, 2009 | 2000 Toyota Land Cruiser

1 Answer

The auto door lock feature dose not work.


There is 3 relays in one of the fuse panels that are labeled doorlocks one of them is probably bad. Push the door lock button and find the one that is clicking this is the one that is back. This should fix your problem

Feb 28, 2009 | 2003 Chevrolet Impala

1 Answer

Auto door locks not working


the noise is the relay clicking for the shift lock release....the auto door lock setting needs to be turned on...it should tell you how in the owners manual...

Jan 14, 2009 | 2006 Chevrolet HHR

1 Answer

Keyless Entry and Remote


I have had this problem take you drivers door put your key and un-lock from the out side with key (NO) then open the door push un-lock from the inside button and then set from you remote and it should set if not push un-lock then lock and then do the un-lock with the key. Let me know if that works. what my car did was locked from the inside and I had the problem were it would not work till I un-locked from the out side plus I had to go to radio shack and change the battery from the control.
Hope good happens.
Nikki2913

Oct 22, 2008 | 1996 Ford Explorer

6 Answers

Jeep alarm will not turn off


The ignition security on/off is located at the trunk lock. unlock and lock rear gate and the alarm will turn off. My jeep sat in my drive for a month before a jeep tech told me this. It still triggers the security sometimes when I unlock the passenger door with the key and I go straight to the rear gate lock and it shuts off instantly.

Jun 27, 2008 | 1994 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

184 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...