Question about 2008 Toyota Yaris Sedan

1 Answer

Yaris egr valve

Can anyone tell me where i could find the egr valve in 2005 yaris

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 840 Answers

Look for a unit that is about 3inches round and about 2- 3 incghes highits usually in the rear by fire wall/ Please rate my response thank you very much

Posted on Feb 02, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Location of the EGR valve for yaris year 2008 as engine is misfiring and scanner indicate EGR faulty. Is it possible and if there is one

The egr valve should be located on or very near the inlet manifold it usually has a stainless steel pipe running towards it these can be cleaned and that's where the fault may lie with it as they clog up and stop working usually if the egr valve is flogged up you may need to check the inlet manifold as this gets worse than the egr aswell at the same time

Apr 16, 2015 | 2008 Toyota Yaris

1 Answer

My 2005 Nissan Altima reads code p0402 could you please tell me what's the problem

The code is exhaust gas recirculation flow excessive detected,
basicly it sounds like your EGR valve is stuck open, i'm guessing it's
a diesel cause it has an EGR valve, so here is what to do, remove EGR valve clean it with brake cleaner or carb cleaner refit and give it a good blast down the motorway! That should do the trick also erase fault! Good luck!

Apr 07, 2014 | Cars & Trucks

1 Answer

I have a 2005 2.7l stratus engine showing code p0175, can anyone tell me what this code is?

code p0175 refers to --system too rich bank 2. causes ---intake blocked---EVAP canister purge valve---fuel pressure---EGR system---injector/s HO2s The first thing I would replace is the o2 sensor in bank2 Use genuine only as the cpu settings may be different to cheapies.. check air filter and the purge valve.

Mar 31, 2013 | 2005 Dodge Stratus

1 Answer

Can anyone tell me where the oxygen sensor is located on a 2005 toyota yaris,1.3 2nzfe engine. i have checked the exhaust pipe all the way down to the tail pipe and have not seen any connections. thanks in...

If it is without Oxygen sensors, then it must be having Idle Mixture Adjustment near the air filter box. It is a variable with hole like adjustment and printed L (lean) and R (rich) on it.

May 07, 2012 | 2005 Toyota Yaris 1.3

1 Answer

Want to clean egr valve myself. has anyone done

Thats simple, Just remove it, Get an old tooth brush and some carb cleaner, spray inside egr, and port where it was bolted, Not to excessive though, then take tooth brush to knock debris loose, Then spray again to insure clean.

Jun 09, 2010 | 1995 Honda Accord

1 Answer

2005 yaris engine struggles when ac and lights are turned on. What are the possible causes?

the possible causes are: alternator low charging, check valve at the valve cover not working.

May 30, 2010 | 2007 Toyota Yaris

1 Answer

2005 Ram 1500 4wd HEMI PO406 - EGR

Hey greenlee99, your best bet would be to grab one these manuals so that you have pictures and diagrams along with step by step instructions. It will tell you what tools and parts you need. Can't go wrong with having it.

Feb 15, 2010 | 2005 Dodge Ram 1500

1 Answer

2005 dodge grand caravan getting code p0406

3.3 engines has the egr valve with have to replace the whole unit. code p0406 what its trying to tell you your egr valve circuit is short to has failed .

Jul 04, 2009 | 2005 Dodge Grand Caravan

2 Answers

2005 Dodge 1500 code p0404 EGR valve.

The electronic EGR valve and solenoid assembly is attached to the rear of the left cylinder head ,

  1. Remove electrical connector (5) at top of EGR valve solenoid.
  2. Remove tube mounting bolt (1) at intake manifold.
  1. Remove two bolts (4) connecting EGR tube (1) to valve assembly.
  2. Remove gasket located between EGR tube flange and EGR valve assembly.
  3. Remove two EGR valve mounting bolts (5).
  4. Separate valve assembly (3) from engine.
  5. Remove and discard metal gasket located between cylinder head and valve assembly.
  1. Clean area at rear of left cylinder head where it joins base of EGR valve.
  2. Clean EGR tube where it joins EGR valve.
  3. Position new gasket between EGR valve and cylinder head.
  4. Position EGR valve to cylinder head. Install and tighten two bolts (5). Refer to Torque Specifications.
  5. Position new gasket between EGR tube flange and EGR valve assembly.
  6. Position EGR tube (1) to side of EGR valve and into intake manifold.
    1. Install EGR tube flange bolt (1) at intake manifold. Tighten bolt. Refer to Torque Specifications.
    2. Connect electrical connector (5) to top of EGR valve solenoid (2).Do a final tightening of two EGR tube bolts (4). Refer to Torque Specifications

Feb 05, 2009 | 2005 Dodge Ram 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

510 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

77939 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8832 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides