- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
first off make sure that the caliper you received is the correct one then remove the caliper bracket with the caliper then remove the bolt which holds the flex hose resecure it back on the new the same way you took it off, then put the brake caliper back on and once everything is back together then open the bleeder screw and allow the fluid to gravity bleed through the caliper, you will have to open the master cylinder resevoir cap so that the fluid can flow through the line and into the caliper, alow this to happen for a couple of minutes then close the bleeder valve and have someone get into the car and press down on the brake pedal while you open the bleeder valve again to get a steady amount of fluid to travel through the caliper. do this a couple of times to make sure there is no more air in the system only then could you put the tire back on the murano
Well you can please follow the below link - 1. Open the rear hatch of the Murano. 2. Remove the screws holding the rear trim covers in place. 3. Pull off the rear trim covers to expose the rear taillight housing assembly. 4. Remove the power connector running to the brake light ballast. 5. Turn the brake light counterclockwise with your hand, and remove the light from the housing assembly. 6. Install the new brake light. Installation is in reverse of removal. Post comments for more help or information......
there is a little piece of spring steel that act`s as a warning when your brake pad`s get low the pad does not look completly worn out take the tire off and double check them or take it to a mechanic you can trust to check them
You probably already figured this out, but you have to remove the wiper arm completely in order to replace the wiper blade.
The blades are an unusual size (somewhere around 14 1/2") and I believe they are only available from a Nissan dealership. They include printed instructions in the box but just in case, this is from the official Nissan service manual: