Question about 2001 Ford F350 Super Duty SuperCab

1 Answer

2003 F 550 blower fan quite how do I change it

The blower fan quite how do I change it

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 424 Answers

If it's the blower motor,the vacuum pump has to be moved out of the way(10 mm bolts) . There are three or four 8mm bolts holding the motor in place. make sure you have power and ground to blower motor before replacing.

Posted on Feb 02, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 bick lesabre blower not working, changed both blower and resistor and fuses. Worked for a few days then quit.


Did you carefully clean out all the debris from the heater box? Did your new blower come with a new fan unit, or re-use the old one? Can you hear the motor run but not blow? These fans are fragile when old, and sometime break right where they attach, thus no blow. If not running, check for current at motor, then resistor, then fuse. Only thing left is the switch.

Jan 06, 2015 | 2003 Buick LeSabre

1 Answer

The blower fan quit working; fuse looks good


the blower should be in the glove box department not really familiar with trucks , it might be that the blower is just dead if so you need to replace it

Dec 26, 2012 | 1993 Dodge Dakota

1 Answer

2004 grand marquis fan quit working..replaced fan but still wont work


is this the blower motor fan for you heating and A/C or the cooling fan cooling fans have a relay blower fans are fused but controlled from switches inside as well as fuses

Aug 27, 2012 | 2004 Mercury Grand Marquis

2 Answers

The blower on my a/c quits working, then starts again, then quits...and so on?? is my blower going out or something unplugged?


if it does this on any fan speed it is most likely a bad blower motor, if it inly while on a certin speed such as full high or full low it could be the fan speed resistor located right near the fan motor, screwed into the fan housing

Jul 31, 2011 | 2001 Pontiac Aztek

1 Answer

1997 jeep wrangler se,fan for a/c and heat quit.all fuses seem good.any other relays or switches jeep have had probs with?


If it only works on Hi, then your resistor is blown. If you can pull the connector to the blower fan and use a voltage tester to find voltage there with the fan switch turned on then it's the blower motor. If there is no voltage there, then its the switch on the dash. Usually the resistor and the switch only die because the blower motor is about to die and is pulling more current then it's supposed to. Change the blower motor too if that's the case.

Jan 10, 2010 | 1997 Jeep Wrangler

1 Answer

Speed changhes on it's own and now it hAS STOPPED


I would see about the blower motor resistor first, it controls the the fan speed, if its not that you probably have a bad blower motor. Good Luck

Dec 08, 2009 | 1999 Jeep Cherokee 4WD

2 Answers

Blower fan resistor module replaced, worked for 2 days quit again


HIGH RESISTANCE IN THE BLOWER MOTOR CAN CAUSE YOUR PROBLEM, OR A BAD RESISTOR.
THERE IS NO REAL GOOD WAY TO CHECK THE RESISTANCE OF THE BLOWER MOTOR.

Jul 16, 2009 | 2005 Chevrolet Malibu

1 Answer

2003 GMC Envoy lower 3 heater fan settings quit working.


had same problem on my XUV. changed the blower motor resistor, located under passenger side dash. easy to change, works no problem.

Jan 20, 2009 | 2003 GMC Envoy

Not finding what you are looking for?
2001 Ford F350 Super Duty SuperCab Logo

167 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

71338 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22059 Answers

Ron Lankford

Level 3 Expert

5386 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...