Question about 2000 Chrysler Concorde

1 Answer

Key is stuck in ignition

I have a 2000 chyrsler concorde and when I shut the engine down the key is not turning all the way to allow its extraction. This was happening sometimes and would work if i drove it around a little. now its been stuck since yesterday.

Posted by on

  • millernjaz Mar 20, 2009

    I have a 2000 Chrysler Cirrus

    The Key is stuck in the ignition but the vehicle runs

    I tried all the internet tricks except for praying for 2 weeks and parking on a hill. I have diconnected the battery and reconnected,yanked on the steering wheel, and cranked it all the way from one side to the other running,off,in neutral,in park. I am open for suggestions.

    Thank You

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 115 Answers

Try makeing sure the shifter is firmly in park. If the shift cable gets slightly out of adjustment the key may not come all the way to the off positon.

Posted on Feb 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 concord heat will not shut off


Does the heater tap actually move in the engine bay? it may be stuck in hot position. dont know if it vacume, electric or cable operated. but check it moves when the temp selector is changed

Jul 14, 2012 | 2000 Chrysler Concorde

1 Answer

Where are the sensors in grand prix 2000 car would die going down road would pull over and wait for stereo clock to shut down the car would restart and may go two or three weeks before doing the same thing...


sounds like a crank sensor went bad.sometimes in early stages they are intermittent then they finally go bad and car wont run. look into that. as far as the key switch it could be orn out or your key could have a small nick on it

Sep 25, 2011 | 2000 Pontiac Grand Prix

1 Answer

Were is the fuel filter on a chyrsler concord e 2000


It is on your left side of the vehicle. Jack it up and look on the top, under the car. You should see the gas lines. Follow them toward the back tire and you will run into the fuel filter.

Feb 26, 2011 | 2000 Chrysler Concorde

1 Answer

The key just wont turn


wiggle the steering wheel vigorously while trying to turn the key..
if the steering has locked, sometimes it will not allow you to turn the ignition..
if its the door keys.. try some WD40 to lubricate.. or change the tumblers.

Oct 09, 2009 | 2000 Chrysler Concorde

1 Answer

Engine problems


If it is the same size engine.Some have 2.7L and others have 3.2L.
I have a 2.7L intrepid engine in my 99 concorde.

Apr 11, 2009 | 1999 Chrysler Concorde

1 Answer

Can not remove ignition key on 1994 Chrylser Concorde


you will need to replace the ignition what you do it place the key in the on position and remove the sterring wheel cover and there is a pin you must push in with a pointed odject once you have the pin in just pull the ignition out and place the new one in thats it the new one will snap in to place once it is pushed back in to place

Dec 04, 2008 | 2002 Chrysler Concorde

Not finding what you are looking for?
2000 Chrysler Concorde Logo

Related Topics:

211 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...