Question about 2000 Chevrolet Impala

2 Answers

2000 impala ls trans problem

I have a 2000 impala it has the 3.4 l v6 when i take off the trans slips and shutters but if i take off real easy its smooth but only in 1 gear taking off other then that it shifts smooth could i need a new trans or i was told it could be a solenoid in the trans is that possable since the trans shifts fine?

Posted by on

  • 1 more comment 
  • bo
    bo Feb 02, 2009

    it dont do it as bad when i take off in low gear as it does taking off in over drive

  • ksp692 Mar 09, 2009

    I have the same problem after my car has been driven awhile and the trans. fluid gets hot.

  • Tyler Blackford Jul 31, 2013

    same happens in mine just asked the same question

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

YOUR PROBLEM IS IN THE TRANSMISSION. THERE 'S A DEVICE CALLED A PCS (PRESSUE CONTROL SOLENOID) VALVE. THIS VALVE MAINTAINS PRESSURE DURING SHIFTING PATTERNS. IF THIS VALVE LOOSES PRESSURE YOU WILL EXPERIENCE THE "SHUTTER/SLIP" SENSATION. TAKE TO A DEALER IF IT'S STILL UNDER WARRANTY SO YOU DON'T BEAR THE BRUNT OF THE COST!!

Posted on Jan 13, 2010

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 80 Answers

The problem is a known issue with the 1 to 2 shift at hard throttle. The fix is a repair of the entire 2nd clutch assy. in the transmission. There is a TSB about it released by Chevy. It will need that rebuild for the sudder to go away, or you can try and let off it at shift to stretch more miles out of it.

Posted on Jun 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

LT 3.9 V-6. Why does A/C clutch have a torque bolt?


Removal & Installation - AutoZone

www.autozone.com/.../Lincoln-LS.../_/P-0996b43f802e888d

AutoZoneLincoln LS 2000-2005 ... If installing a new A/C compressor, the A/C clutch disc and hub , A/C ... If flushing of the air conditioning system has not been performed, recover the refrigerant. ... Remove the bolts and lower the A/C compressor. ... The torquespecifications of the A/C manifold and tube assembly-3.0L engine shown.

2006 CHEVROLET IMPALA 3.9L V6 Auto Parts - RockAuto

https://www.rockauto.com/.../x,carcode,1438246,d,2006_CHEVROLET...
RockAuto has parts for your 2006 CHEVROLET IMPALA 3.9L V6 and all ... Who needs AutoZone or NAPA when all the parts your car will ever need are right here? ... 2006 CHEVROLET IMPALA 3.9L V6 Electrical-Connector Parts, A/C and .... IMPALA 3.9LV6 Suspension Parts, Ball Joint Caster / Camber Cam Bolt Kit Coil

Nov 14, 2015 | 2006 Chevrolet Impala

1 Answer

I just bought a 2012 Chevy Impala. The gas cap never tightens. Is this normal?


Some gas caps have a built in slip preventing over tightening, so no engine light, no worry. The cap will feel like a ratchet effect when you tighten, so it slips at point it is sealed so you don't crush rubber seal. Not to worry as I see it.
CERACOAT-NANOTECH.com

Apr 21, 2015 | 2012 Chevrolet Impala LS Sedan 3.6L V6 FFV...

1 Answer

My Lincoln ls v6 2000 transmission is slipping and making my reverse go out what can I use like Lucas ?


You do not put anything in any transmission except
the correct fluid

In your case Mercon V

Your trans is done,worn out,need a new one.

Fluids & additives fix NOTHING

May 02, 2014 | Cars & Trucks

1 Answer

Where is the oil pressure sensor on a 2007 Impala LS 3500 V6?


I think it is located near the bottom of the oil pan on the back side, you will probably have to drain the oil but I'm not sure. That is where mine is located however mine is a 2000 Chevy Impala LS.

Sep 12, 2013 | Chevrolet Impala Cars & Trucks

1 Answer

Transmission slips


Hi there,

About the transmission slipping, which I have heard several complaints about, it might be an improper gear ratio code pop up and a gear slipping code popup. I would like to know in what gear it actually slips.

A common problem is also that the servo bores wear out and the servo piston gets cocked and breaks or the band just burns up.This could also be your gear ratio error.The fix is to drill out the servo bores and sleeve them. If you get an overhaul, which I believe any dealership you take it to would advise you to do, make sure they do that whether it needs it or not. If you can find a used trans that is extremely low mileage then I would buy it. A real low mileage trans will be very clean(bolts still shiny).

Hope this helps...

Jan 14, 2011 | 2000 Lincoln LS

2 Answers

Firing order for plugs and wires....on a v6 3800 2000 impala


For the 2000 Chevrolet Impala 3.8L V6:

Firing Order:
1-6-5-4-3-2

Cylinders:
.....(back).....
|...2...4...6...|
___________
|...1...3...5...|
.....(front)

Ignition Coil Connections:
(back)
o <---6
___
o <---3
o <---2
___
o <---5
o <---4
___
o <---1
(front)

Let me know if this helped, or if you have additional information or questions. Feel free to contact me at FixYa.com!

Apr 18, 2010 | 2000 Chevrolet Impala

1 Answer

Since my 2001 Lincoln LS (v6) does NOT have a transfill tube...


You have NO reason to top off ANY fluids,if you think about it. If you had a leak,you would repair it. Fluids don't get consumed. You can do whatever you want,it is your vehicle. On the LS and most fords the instructions are on the bottom of the trans oil pan. The fill,is the plug on the tail housing. You have,to have the correct filler container and a compressor,to blow it in, or make up one. Mercon V -on the fluid. You have to put the car on 4 jack stands,to get under it, and better know where to support it. I have a 2004 LS and it isn't very easy to work on. I assume you have issues,or the trans shop wouldn't have been mentioned. The solenoid trans pack,fail on these, as well as the TPS,EGR,and many Ignition coils. Change/flush the Power Steering Fluid. Regular Mercon, not V. Don't forget the Cabin Filter,under the plastic wiper cowl cover,pass side. Gas filter behind driver side wheel well, plastic cover,remove tire first. Push on release with fingers,don't pry up with screw driver?

Mar 15, 2010 | 2001 Lincoln LS

1 Answer

Cherolet 2000 malibu belt keep slipping off


SOUND LIKE A BAD BELT TENSIONER OR YOU HAVE WRONG SIZE BELT.

Oct 25, 2009 | 2000 Chevrolet Malibu

2 Answers

2000 isuzu rodeo trans range and leak problem at $1000?


leak.... where.... flush is easy... dont take it in..... get the filter and gasket and do it yourself........ whats the code... i will tell u what it is :D

Mar 17, 2009 | 2000 Isuzu Rodeo

1 Answer

Transmission in my 2005 Impala LS shifts real hard occassionaly.


SOUNDS LIKE STICKING VALVE BODY GO TO YOUR LOCAL AUTOPARTS DEALER AND BY A BOTTLE OF THERE SHIFTING HELP PRODUCT B&M IS GREAT STUFF AND AFTER THAT I WOULD WAIT ABOUT A WEEK AND HAVE TRANS FILTER CHANGE AND TRANS FLUILD TWO POSSIBLY EVEN HAVE IT FLUSHED

Feb 01, 2009 | 2005 Chevrolet Impala

Not finding what you are looking for?
2000 Chevrolet Impala Logo

739 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...