Question about 2000 Pontiac Bonneville

1 Answer

O2 SENSORS I have 2000 bonneville ssei supercharged and i need to change both o2 sensors in it. I need to know where they are located at and are they easy to replace?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 15,935 Answers

#1 Under vehicle, center, below seating area, next to catalytic converter, mounted on exhaust pipe.

#2 Under hood, center, rear engine area, above exhaust pipe flange, mounted in exhaust manifold.

Easy to access.

Thanks for using FixYa - a FixYa rating is appreciated!!

Posted on Feb 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Image of o2 sensor & location on Bonneville 1997 ssei


Which O2 sensor ? Bank 1 sensor 1 or bank 1 sensor 2 or bank 2 sensor 1 or bank 2 sensor 2 . What size engine ?

Oct 30, 2015 | Cars & Trucks

1 Answer

I need timing mark on 2001 Pontiac Bonneville supercharged ssei


find it on the HArmonic And Look For No 1 on the top and ther Done and you will have it be carefull you are not out cause big problems then turn over by HAnd Not with the Starter to make sure your on it

Mar 22, 2015 | 2001 Pontiac Bonneville SSEi

1 Answer

When I turn on the ac or the heater on my 1992 pontiac bonneville ssei supercharged it will now air to the windshield but when I change it to blow to me or my feet it won't blow any air. what coul


there is a paddle inside the sysem which moves to change the direction of the heat, i could be jammed or its actuator is broken or not getting pwer. if not it could be your switch is not working so the sigal to change position is not be received. first check all fuses are ok.

I hope this was useful.

Sep 02, 2012 | Cars & Trucks

1 Answer

How do i change the supercharger oil on my pontiac bonneville ssei 2003


google it theres a little screw by your manifold off a line i think

Aug 16, 2011 | 2003 Pontiac Bonneville

1 Answer

1997 Pontiac Bonneville Supercharged SSEi need the location of data link connector


The Data Link Connector is located under the driver's side dash panel, by the footwell.

Apr 27, 2011 | 1997 Pontiac Bonneville

2 Answers

Hi i have a 2000 bonneville ssei supercharged 3.8 my car keeps choking up when i push on the gas pedel and on the highway on cruise at 80kms keep sputtering and get a black smoke from my exaust and...


i had a 91 gmc car, it was fuel injected &(if it was carburated) ran like the choke was stuck,i changed the thermostate sensor & relay(relay cost more)sounds like your car.the computer was getting information that the car was cold.if you can find a manual for your car check trouble shooting. i dont want to plug a company but HAYNES makes a quality manual.hpe this helps

Apr 09, 2011 | 2000 Pontiac Bonneville

1 Answer

2001 pontiac bonneville SSEi 3.8 l supercharged. The car runs smooth for 15-30 min then stalls out. And when you attempt to restart it starts and idles up and down. And dies after 30 sec. With no check...


I have a 2000 Bonneville - I had a problem with the car stalling out - then it did not want to start back up. (When it did it would idle up and down and then die) I changed out the mass air flow sensor - now I have not had a problem. Good luck with it.

Feb 10, 2010 | 2001 Pontiac Bonneville

1 Answer

Engine swap


I believe the 1995 S/C 3.8L changed in 1996 (switched to series II). I do know for sure that the normally asperaited 1995 had a Series II 3.8L.

If this is true (series I in 1995 S/C), quite a lot could possibly need changed.

May 14, 2009 | 1995 Pontiac Bonneville

2 Answers

Pontiac Bonneville(2000) oil pressure sending unit


The oil pressure sending unit is located behind the oil filter, Threaded into an aluminunm housing. It has wiring that plugs into the sending unit. The oil filter has to be removed and you will need a deep well socket and a 6 inch extension. Change the oil and the sending unit together.

Jan 24, 2009 | 2000 Pontiac Bonneville

Not finding what you are looking for?
2000 Pontiac Bonneville Logo

351 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...