Question about 1998 Mercedes-Benz C-Class

1 Answer

The turn signal lens cracked on my mirror of my sl55 how do i take it off

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 64 Answers

It slides off

Posted on Feb 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you replace the mirror


Is just the bulb burned out in the mirror signal lens??

Jul 13, 2016 | 2010 Chrysler Town and Country

1 Answer

How do I replace the turn signal light on the drivers side view mirror?


If the signal flashes on the outside of the glass, then the yellow lens will pop off the mirror assembly using a small screwdriver etc for bulb access. If the signal flashes inside the mirror assembly, the mirror will need replacement or there is a wiring issue

Jun 21, 2015 | 2004 Ford Freestar

2 Answers

How do I change the bulb in the door mirror on a Volvo S80 2004


If it's the approach light under the mirror, the lens pops out to replace the bulb. If it's the turn signal bulb, then the mirror cover has to come off

Feb 16, 2015 | 2004 Volvo S80

1 Answer

How to replace side turn signal lens door mirror


Check to see if there is a hidden screw on top or on the other side. If there is none, try to move the lens side a little bit before pulling it outwards, a tab on the back must be holding it.

Feb 02, 2014 | Cars & Trucks

1 Answer

How do you install turn signal lens on side mirrors on a 2005 F250?


- Adjust the mirror so the mirror glass is in as far as it will go (meaning if you were looking in the mirror you would see the side of the truck)

- Look inside the mirror housing
- Locate silver clip
- Using a flat screw driver, push the clip in
- Lenses will pop out on the outside
- Remove bulb
- Replace bulb
- Snap back together when new bulb in place.

May 02, 2010 | 2008 Ford F-250 Super Duty

1 Answer

How do you replace the turn signal light in the mirror of a 2007 rabbit


Its tricky, you have to take the whole mirror apart in order to take the clear lens out where the light comes from. you cannot just replace the bulb. you have to replace the clear lens that comes with a built in led light.
first you pull on the mirror glass. do this very gently.. start from the top on the glass and pull very gently until the mirror comes off.. if you have a heated mirror, after you pull the glass, you will have to disconnect the wire. then you will see 3 torx screws that hold the top part on the mirror. losen those. take the top part off, then from behind you will see two more screws which you losen to remove the bottem part of the mirror. then you will see to clips that hold the led blinker in place. push on those carefully and it should come out.. you will also have to be carefull when you dissconect the wire from the led turn signal. as you might break the clip.. then replace it and follow the these step backwards..

Nov 14, 2009 | 2008 Volkswagen Rabbit

1 Answer

Left front turn signal lens cracked.


Check this info KJ-2002-Liberty-Service-Manual-PDF-Secc-08-Electrical-Systems ( 8L-1 page 165 and next) about headlight remove instructions.

Good luck!!!

Jul 19, 2009 | 2006 Jeep Liberty

2 Answers

Change puddle light , need to know how to take the lens off to change the light bulb in the mirrior of a 2003 ford expedition .


Per the '03 Owners manual...

Approach lamp bulb removal (if equipped)
To change the bulbs:
1. Make sure that all the doors are
closed and the interior lights have
automatically turned off or the
opposite mirror approach lamp has
turned off.
2. With a small flat tipped
screwdriver, insert the tip into the
approach light module slot located
on the outboard corner of the lens
to release the clip.
3. While holding the clip in the release position, pull the approach light
module down.
4. Remove the two wires from the module and replace the module with a
new one.
5. Reverse the order to reassemble the approach light module.

Jul 04, 2009 | 2003 Ford Expedition

3 Answers

How do I change the Drivers side Turn signal bulb in the mirror?


Actually the first answer was right.  On my 2007 Sprinter chassis, the side mirrors have an upper flat mirror and a lower convex mirror.  The upper mirror comes off exactly as described; by tilting it so that it faces down, and then gently lifting it from the top to slide it off the track. (On my sprinter the mirrors are heated, so there are wires that remain attached when you slide it off. This reveals three screws that you can get at with a torex screw driver without needing any flexible shafts etc.  It appears that there is a fourth screw or clip of some sort on the bottom, but I was not able to figure out how to get the bottom convex mirror off to get at it.  That would enable the removal of the full shell. Even without that bottom screw I was able to flex the shell enough to get the turn signal lens assembly out.  But removing it entirely requires reaching in with needle nosed pliers and rotating the bulb assembly a quarter turn, and then reversing the whole assembly to get it back.  In my case I was replacing the turn signal lens, but it should work the same for replacing the bulb. Good luck.

Jan 26, 2009 | 2004 Dodge Sprinter

Not finding what you are looking for?
1998 Mercedes-Benz C-Class Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

yadayada
yadayada

Level 3 Expert

61037 Answers

Michael Contreras
Michael Contreras

Level 2 Expert

164 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...