Question about 2002 Kia Sportage

1 Answer

Transfer case i have a 2002 sportage with no 4 wheel drive i shift it into 4-h or 4-l and nothing the light on dash comes on it is a auto trans

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Kia Master
  • 77,202 Answers

U WILL NEED TO PULL THE TRANSFER CASE ACTUATOR MOTOR OFF THE TRANSFER CASE AND TEST IT, MOST LIKELY IT IS DEFECTIVE.

Posted on Feb 02, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 Silverado 4WD. Service 4WD dash light comes on after engaging 4WD and acts up by engaging itself randomly for several days, then goes back to normal.


Check connection at the 4X4 control module , check power and grounds . Do you know how to do basic electrical testing ? Does your truck have manual or automatic trans mission ? Which transfer case does yours have ?

The NVG 263 transfer case features a three button shift control switch located on the instrument panel. When the ignition is in the RUN position, the transfer case shift control module (TCCM) starts monitoring the transfer case shift control switch to determine if the driver desires a new mode/gear position. At a single press of the transfer case shift control switch, the lamp of the new desired position begins flashing to inform the driver that the TCCM has received the request for a new mode/gear position. The lamp continues to flash until all shifting criteria has been met and the new mode/gear position has been engaged. Once the new mode/gear position is fully active, the switch indicator for the new position remains ON constantly. In the event that the TCCM can not or will not complete the shift, the indicator returns to the previously selected position; this is a Transfer Case Shift Control Switch Indicator Flashes, then Returns to Previous Mode condition.

The NVG 263 transfer case provides the driver with 4 manual mode/gear positions:
• 2HI - 2 Wheel Drive high range
• 4HI - 4 Wheel Drive high range
• 4LO - 4 Wheel Drive low range
• Neutral
Have it check for DTC'S - diagnostic trouble codes ?

DTC B0790
DTC B2725
DTC C0306
DTC C0327
DTC C0359
DTC C0379
DTC C0550

Your best bet would be take it to a qualified repair SHOP

Dec 28, 2016 | Cars & Trucks

1 Answer

I own a 02 foard explorer shift motor was bad i think and i removed it, i started it to relocate it, installed the new shift motor


Don's 1999 Ford Ranger shift motor PROBLEM SOLVED ...

? 13:05
https://www.youtube.com/watch?v=wcn39gwPWfI
Oct 1, 2013 - Uploaded by gtarman49
Don's 1999 Ford Ranger shift motor PROBLEM SOLVED. ...How to find replace fix 4x4 transfer case shift module 2002 Ford Explorer 4 wheel ...

How To Install Replace 4x4 Transfer Case Shift Motor Ford ...

? 9:15
https://www.youtube.com/watch?v=9ldrtZODxQ8
Oct 26, 2010 - Uploaded by 1A Auto Parts
How To Install Replace 4x4 Transfer Case Shift Motor Ford Explorer .... transfer case shift module 2002 Ford Explorer 4 wheel drive not working ...

How to find replace fix 4x4 transfer case shift module 2002 ...

? 3:07
https://www.youtube.com/watch?v=sZw3SS2Pt-4
Nov 3, 2013 - Uploaded by kirk colombo
... transfer case shift module 2002 Ford Explorer 4 wheel drivenot working ..... I replaced the transfer motor so i think it is the control module.


Jan 08, 2016 | Cars & Trucks

2 Answers

Why won't my Tahoe shift into 4 wheel drive


The most common issue is the encoder motor on the the transfer case.

Oct 18, 2014 | 1997 Chevrolet Tahoe

1 Answer

2002 Silverado 1500 push button 4 wheel drive issue Light will light showing it is in 4 wheel drive but it is not. Auto button seems to work though.


2 speed electric shift transfer case problems #1 jack up truck place on 4 jack stands. Start and select 4 high position in drive release brake ad watch front driveshaft does it turn "yes" problem is axle actuator on passenger side of differential not engaging axle shaft. "no" apply brakes bring to a stop engage low range does low range work "yes" internal transfer case problems "no" electric transfer case shifting motor failure.

Oct 26, 2013 | 2002 Chevrolet Silverado 1500

1 Answer

2002 f150 4wd drive not not working,


Transfer Case - Electronic Shift on the Fly (ESOF) Features A rotary switch allows the vehicle operator to choose between 2WD, 4H, and 4L modes of 4x4 operation.
The generic electronic module (GEM) controls the operation of the 4x4 system.
The output shaft speed (OSS), mounted in the rear of the transfer case, informs the GEM of the vehicle speed.
The shift motor sense plate, an integral part of the electronic shift motor, informs the GEM to the positions of the transfer case (go to Table 4).
The transmission range sensor is located on the LH side of the transmission; this sensor informs the GEM when the transmission is in the NEUTRAL position.
The electronic shift motor, mounted externally at the rear of the transfer case, drives a rotary cam which moves the mode fork and range fork within the transfer case to select between the 2WD, 4H, and 4L positions.
The 4x4/4x2 vacuum solenoids are attached to the upper RH side of the engine compartment, and alternately route vacuum to the vacuum motor which engages/disengages the center axle disconnect collar in the front axle assembly.
The 4x4 shift motor relay is a module containing two relays. Under the control of the GEM, the 4x4 shift motor relay shifts the transfer case shift motor between the 2WD, 4H, and 4L modes.
The transfer case clutch relay is an electromechanical relay used to activate the transfer case clutch within the transfer case.


Your best bet , take it to a qualified repair shop !

P1804 Transmission 4-Wheel Drive High Indicator Circuit Failure GEM REFER to Section 413-01A . P1806 Transmission 4-Wheel Drive High Indicator Short Circuit to Battery GEM REFER to Section 413-01A . P1812 Transmission 4-Wheel Drive Mode Select Circuit Failure GEM REFER to the Symptom Chart. P1815 Transmission 4-Wheel Drive Mode Select Short Circuit to Ground GEM REFER to the Symptom Chart. P1820 Transmission Transfer Case Clockwise Shift Relay Coil Circuit Failure GEM GO to Pinpoint Test A . P1822 Transmission Transfer Case Clockwise Shift Relay Coil Short Circuit to Battery GEM GO to Pinpoint Test A . P1824 Transmission 4-Wheel Drive Clutch Relay Circuit Failure GEM GO to Pinpoint Test E . P1826 Transmission 4-Wheel Drive Low Clutch Relay Short Circuit to Battery GEM GO to Pinpoint Test E . P1828 Transmission Transfer Case Counter Clockwise Shift Relay Coil Circuit Failure GEM GO to Pinpoint Test A . P1830 Transmission Transfer Case Counter Clockwise Shift Relay Coil Short Circuit to Battery GEM GO to Pinpoint Test A . P1832 Transmission Transfer Case Differential Lock-Up Solenoid Circuit Failure GEM GO to Pinpoint Test C . P1834 Transmission Transfer Case Differential Lock-Up Solenoid Short Circuit to Battery GEM GO to Pinpoint Test C . P1838 Transmission Transfer Case Shift Motor Circuit Failure GEM REFER to the Symptom Chart. P1846 Transmission Transfer Case Contact Plate 'A' Circuit Failure GEM REFER to the Symptom Chart. P1850 Transmission Transfer Case Contact Plate 'B' Circuit Failure GEM REFER to the Symptom Chart. P1854 Transmission Transfer Case Contact Plate 'C' Circuit Failure GEM REFER to the Symptom Chart. P1858 Transmission Transfer Case Contact Plate 'D' Circuit Failure GEM REFER to the Symptom Chart. P1866 Transmission Transfer Case System Concern - Servicing Required GEM REFER to the Symptom Chart. P1867 Transmission Transfer Case Contact Plate General Circuit Failure GEM REFER to the Symptom Chart. P1876 Transmission Transfer Case 2-Wheel Drive Solenoid Circuit Failure GEM GO to Pinpoint Test C . P1877 Transmission Transfer Case 2-Wheel Drive Solenoid Circuit Short to Battery GEM GO to Pinpoint Test C . P1891 Transmission Transfer Case Contact Plate Ground Return Open Circuit GEM REFER to the Symptom Chart.

Nov 26, 2017 | 2003 Ford F150 Regular Cab

1 Answer

Transfer casenot shifting into 4x4,03 silv. z71 auto.trans,auto shift buttons flashing but goes to 4lo only but no 4x4


The problem could be the 4 wheel drive buttons or the transfer case encoder motor on the side of the transfer case.

Oct 19, 2010 | 2003 Chevrolet Silverado 1500

2 Answers

HOW TO USE 4 WHEEL 1980 CHEVY K20 PICKUP


have truck running,,put shifter in neutral,,shift into high lock 4x4,then put truck into gear,,u can shift from high lock to high gear,,from two wheel to four wheel,,in high only,,if u want to shift transfer case in low,,u have to put truck in ,,neutral,,first,,

Feb 06, 2010 | Chevrolet K2500 Cars & Trucks

1 Answer

LAST WEDNESDAY WHILE OUT ON THE BACK ROADS, I DECIDED IT WOULD BE A GOOD TIME TO RUN THRU MY 4 WHEEL DRIVE (ELECTRONIC 2H, 4H, 4L, & ALL WHEEL), ALL OF THE SHIFTS WENT FINE, AND I THEN DROVE HOME. IN...


sounds like you have a combonation trans and transfer case issues. if you were running youre truck in four wheel on a hard dry surface, witch is not recomended , the trans probibly ran hot. as for the transfer case, it could be a combination of problems. dash switch/ actuator/vacum switch/ vacum canister witch is under the battery tray. all have to work in unison. service the trans first. if the truck has high miles, add trans conditoner, if you do not, it will slip. then the transfer case. refer to youre owners man for oil specs. youre problems are not uneque as these trucks are notorius for unreiable four wheel actiuation. hope i was some help.

Oct 27, 2009 | 2000 GMC Jimmy

1 Answer

How to shift into 4wd


Ford has 2 types of 4x4 system engagement. One is a knob on the dash that you just turn to 4wheel drive high or low. The other system is the 4x4 transfer case shift on the transmission tunnel (hump) between the driver and passenger seats. To shift into 4 wheel drive high while driving, just let off the gas and shift transfer case into 4H position, and continue driving. To shift into 4 wheel drive Low, stop the vehicle completely, put transmission in neutral, shift transfer case into 4Low position, put trans. in gear, and start driving. I am assuming before doing the above, you have locked in ( turned the front hubs to 4 wheel drive position.) Any further questions, let me know.

May 16, 2009 | 2003 Ford F150 Regular Cab

Not finding what you are looking for?
2002 Kia Sportage Logo

133 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

yadayada
yadayada

Level 3 Expert

77201 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...