At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
hello,have you check your wiper relay located on top of main fuse box,maybe poor contact,or your combination switch for wiper have worn-out mechanism,or your wiper motor need tobe check the condition,ty
Sounds like the jolt from the barrier has caused a bad ground to occur. Look for a bad ground wire around the left headlamp in or around the headlight bucket. Tighten or replace the bad ground wire. A poor contact will cause the headlight to light dimly.
Sure they did your multifunction switch is the wipers and turn signal and hi low beam switch your headlights have to run through that switch also so you can dim or brighten them
Remove the ash tray assembly and the finish panel (snaps off).
On the Explorer, remove the rear window wiper and heated backlite switch assembly (snaps out).
On the Ranger, remove the storage bin (snaps out).
Pull the headlight switch knob to the headlight on position. Depress the shaft release button and remove the knob and shaft assembly.
Fig. 1: View of the 1991-94 model headlight switch control knob release button
On 1995-99 models, remove the instrument panel finish panel.
Unscrew the mounting nut and remove the switch from the instrument panel, then remove the wiring connector from the switch.
Fig. 2: Exploded view of the 1995-99 model headlight switch componentsTo install:
Connect the wiring connector to the headlamp switch, position the switch in the instrument panel and install the mounting nut.
On 1995-99 models, install the instrument panel finish panel.
On 1991-94 models, perform the following:
Install the headlamp switch knob and shaft assembly by pushing the shaft into the switch until it locks into position.
On the Explorer, install the rear window wiper and heated backlite switch assembly.
On the Ranger, install the storage bin.
Install the finish panel and the ash tray assembly.
Connect the battery ground cable, and check the operation of the headlight switch.
On my 850 the headlight wipers come on the same time as my windshield wipers when I pull the lever to squirt washer fluid on my windshield. The back wiper should be on an independent switch.
×