Question about 1996 Chevrolet Tahoe

1 Answer

Wont start 1996 tahoe 1500

Truck wont start bang computer starts right up sometimes cuts out when driving bang computer starts up again 1995 57 vortec 1500 what do you think one day will bang sure wont start help

Posted by on

  • firebird0120 Feb 01, 2009

    replaced with junkyard ecm had same problem no burnt pins pins all straight trying another ecm

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 94 Answers

SOUNDS LIKE YOU HAVE CONECTOR PROBLEM .CHECK ALL CONECTIONS AT COMPUTER. SPECIALLY POWER AND GROUND . CHECK FOR BURNT PINS AT COMPUTER . IF ALL GOOD YOU SHOLD REPLACE ECM.

Posted on Feb 01, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I put in a new fuelpump and my tahoe will not start if i let it sit 2 to 3 days without starting whats going on


Vortec motor? 5.7 ? if so, likely fuel hoses to injector leaking fuel within intake causing lost of prime pressure and fluding engine with fuel

Dec 16, 2012 | 1996 Chevrolet Tahoe

2 Answers

1998 chevy k1500 idle fast


Sounds like it could be a dirty or faulty idle air control valve.Take it off and clean it with a wire brush and a non-chlronated brake cleaner or replace it with a new one.Make sure you reset the computer after cleaning or replacing the valve.

Nov 18, 2011 | 1999 Chevrolet Silverado 1500

2 Answers

1996 chevy tahoe 5.7l vortec , fuel pressure is 50 psi and runs perfect but when you give it gas it bogs out and wont go


YOUR LUCKY IT RUNS AT ALL THAT IS LOW PRESURE LOOKS LIKE FULE PUMP TIME FULE PRESURE NEEDS TO CLOSER TO 60 LBS PLUS THATS WHY IT IS BOGGING OUT YOU CAN TRY CHANGING THE FUEL FILTER BUT IT LOOKS LIKE TIME FOR ANEW FULE PUMP HOW OLD IS THE PUMP AND WHAT IS THE MILAGE ON THE TAHOE 150K PLUS RIGHT OR MORE

Mar 03, 2011 | 1996 Chevrolet Tahoe

2 Answers

I have 1996 chevy tahoe 350 vortec i have spark , fuel, and new throtle position sensor still only crank over no start though


unplug your mass air flow sensor i havd the same problem with my 97 tahoe unplug it and it should run

Jan 06, 2011 | 1996 Chevrolet Tahoe

1 Answer

1996 gmc k1500 4x4 5.7 vortec motor no start keep


Replace the coolant sensor on the front of the intake manifold.The coolant sensors on this engine does go bad and wont set a check engine light. The sensor will read about -32 to 0 degrees when they do go bad. The computer thinks it is that cold and sends tons of fuel to the engine. If you try to start the engine with the throttle depressed to the floor it puts the fuel system in clear flood mode and wont fire the injectors. Engine will start then and run very rich. The coolant sensor has two wires on it and sometimes you need to replace the wiring pigtail going to it as the sensor can seep coolant into the connector and corrode the terminals. All the parts are available at pepboys and autozone or napa. Good luck

Jan 05, 2010 | 1996 GMC Sierra

2 Answers

1996 Chevy 1500 4x2 5.7 vortec. Will not start I started having a problem with the truck not wanting to start sometime. it turns over but not start. what i do know is that it is getting gas. i can hear the...


I have had this problem on my 89 and my 94 gm trucks what it was is the pick up inside the distributor time to rebuild it (not the cap and rotor) the little thing inside with all the wire wrapped around something- copper wire with a clear coating on it the coating get hot and cracks causeing it to ground out when the vehicle warms up run ok until u shut it off then no start or runs rough

Nov 23, 2009 | 1996 Chevrolet K1500

1 Answer

Starting problem


Do you have a security light flashing? Sound like a theft system problem. Some 1996 Tahoes had passlock.

Jun 01, 2009 | 1996 Chevrolet Tahoe

1 Answer

1996 tahoe bangs gears after short drives on warm days


check your rear brake shoes if you had them changed recently they may not have been adjusted properly and that sometimes will cause that and also check the rear diff yoke where the driveshaft goes insometimes it get gear oil on it and harder for it turn. i would try these hints first before i take to shop

May 29, 2009 | 1996 Chevrolet Tahoe

2 Answers

Stops running


idle air control valve is slow or clean our air intake thank you Pierre

Jun 23, 2008 | 1998 Chevrolet K1500

Not finding what you are looking for?
1996 Chevrolet Tahoe Logo

Related Topics:

223 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6864 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...