Question about 2005 Chevrolet Silverado

1 Answer

Power window off track

Drivers side window was frozen up when i pushed the button motor ran but window stayed up. When the ice let go the window fell into door.I was able to pull the window up and then push the button which now holds the window up

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 107 Answers

Window regulator assembly are built cheap , about an hour to change with experience

Posted on Feb 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The drivers side window fell into the door of 96 rendezvous. How do i put it back on track?


The door trim is held on with a combination of screws and push clips Once you have the trim off you will probably find that the window motor regulator is defective. I would recommend replacing the regulator and motor as an assembly.

Are you sure of the year? Didn't think that they made a 1996 Buck rendezvous

.http://www.dormanproducts.com/gsearch.aspx?

Feb 23, 2015 | Cars & Trucks

1 Answer

VW bettle 2000 power window fell down power motor works but won't lift window drivers side


You may have a number of problems, all can be answered by removing the door pnl and inspecting. The window may have fallen out of the track, the window motor may have fallen out of the regulator, the motor's drive system may have stripped or broken, the regulator itself may have failed or broken or the window is no longer attached to the regulator. Pull the pnl and start inspecting. Good luck!

Jan 17, 2012 | Cars & Trucks

1 Answer

1996 nissan pathfinder driver side window won't go up and down


does it click or grind when pushing window button if so the window lift track may need replaced, if there are no sounds then disconnect the wires from the lift motor and with the ignition on so power is sent to switch, push button and check wires to 12 volts dc. If no power I would replace the driver side switch after checking the wires for defects. If there is power then I would re-install wires to motor after turning off key and try button again with power on. replace motor if it doesn't work.

Dec 31, 2011 | 1996 Nissan Pathfinder

1 Answer

The driver side window of my 2004 Nissan Maxima just slid down in the door panel. I managed to pull it all the way back up. Also, before the window fell when I pushed the switch I could hear the motor...


Your window is probably still on track but the window regulator is shot and will need to be replaced if the glass moves freely and the motor spins without moving the glass.

Sep 10, 2011 | 2004 Nissan Maxima

1 Answer

Passenger side window fell down when pressed down button. now wont go back up and wont stay up when pushed up


Take it to an auto glass shop, the window has fallen out of the track attached to the regulator. If there is no whining motor sound the regulator may have died as well and you need to look around on ebay for a replacement, Since the driver door regulator usually dies first however, I would bet on the regulator being good, window just out of track. A glass shop can fix that for you in a few hours for less than a hundred bucks. If price is not a factor then a dealer can do it for you for about 500 bucks.

Aug 06, 2010 | 2000 Cadillac Escalade

1 Answer

Power window off track, motor still works


your window does not ride on a track the motor has a gear that drives a mechanism up and down. it sounds like the motor came loose.
pop the door panel and remount the motor, first pull the window all the way up. hope this helps

Dec 24, 2009 | 1997 Buick Skylark

3 Answers

Cannot get the rear window to stay up . the drivers side rear window slides down as I drive.


Either the window fell off the track or the motor is faulty. You will most likely have to remove the screws and then pry off the door panel to access the window, frame, and motor

Sep 21, 2009 | 2000 Pontiac Bonneville

1 Answer

2003 Chevy Malibu driver's window won't work


If it is a very loud noise, then it may be the window regulator. This is the assembly that the motor and glass bolt to. The door panel would have to come off to inspect.

Dec 06, 2008 | 2003 Chevrolet Malibu

1 Answer

Power window


It is probably just off of the track. It could be worse. take the door apart and put the window back in the guide (track). Hope this helps.

Aug 31, 2008 | 2000 Dodge Durango

Not finding what you are looking for?
2005 Chevrolet Silverado Logo

186 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...