Question about 2000 GMC Safari

Open Question

How to remove airbag

How do you remove passenger air bag from 2000 gmc safari

Posted by on

6 Suggested Answers

  • 5 Answers

SOURCE: turn airbag off

It should turn itself off and on based on the weight of the passenger.

Posted on Apr 08, 2009

  • 718 Answers

SOURCE: air bag remove 98 gmc sonoma

If the brake lights will not turn off, the switch on the brake pedal is shorted or damaged. Look for it on the brake pedal under the dash. You will not need to remove the steering wheel.

Posted on Apr 15, 2009

clarktravis8
  • 74 Answers

SOURCE: 2000 GMC Safari anti-lock brakes

There was actually a recall for this. Go to your local GMdealer and have them check your VIN for a recall. If not under recall get out of there its easy to repair yourself don't let'em fool you.Remove the front pads caliper and rotors. Locate the abs sensor mounted to the wheelbearing assembly by a small socket head cap screw (Allen wrench). Removethe bolt and softly gently/wiggle the abs sensor around until it pops upout of the hole. some will break, which is why it wouldbe nice if the recall applies to your vehicle that way if they break gm replaces. Once you get both sides removed, clean themounting surface of all rust or build up with w-d 40 and small steel toothbrush then wipe off excess with clean rag and mild soap and warm water, dry completely make sure no spray residue exist on parts, Next apply a thin layer of lubricant grease to preventfuture rusting and reassemble.The rust build up under the sensor is causing the angle to change resultingin inaccurate wheel speed readings in the abs module your abs module will interprets this asa wheel is either slipping or skidding and applies your abs. This should make you happy with no more irritations. Please rate me. If you need further assistance you can always ask me. Good luck with this.

Posted on Apr 25, 2009

localwonder
  • 6784 Answers

SOURCE: 2000 Dodge Caravan - Air bag light comes on.

This is a signal of a bad abs sensor. replace the abs sensor asap.

Posted on May 26, 2009

csmock132
  • 4669 Answers

SOURCE: Air bag light won't go off

It likely is a bad passenger air bag. Did you try switching it back to off on the switch,and unhooking the battery for 5 minutes.

Posted on May 30, 2009

  • 85 Answers

SOURCE: no air coming out of vents on 2000 gmc safari

it sounds like the hvac mode acuator which controls where the air goes. if it still blows through def or floor thats what it is

Posted on Feb 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Remove the passenger side airbag


disconnect the electrical connector for the air bags. it will be a yellow connector with a safety lock on it. then remove the dash board/pad turn upside down and unbolt the air bag. this is the simplified version. there will be some things that need to be undone from the dash pad.

Mar 09, 2015 | 2000 Ford Escort

1 Answer

How to remove front passenger side seat


Always disable the air bag system first, to prevent accidental deployment of the air bags. The main airbag module is beneath carpeting under passengers seat. To remove passengers seat, At the rear of the seat remove the two bolts securing the tracks to the floor, tilt the seat up and towards the instrument panel, unplug any electrical connectors beneath and remove the seat. the front plastic track covers can remain in place while the seat track tabs are lifted out of the slots on the floor. ( caution disable airbag before removing the seat ) Good-Day! Hope this helps you!

Sep 12, 2014 | 2000 Chevrolet Malibu

1 Answer

Turn off passenger airbag


if this has no shut off switch for the passenger airbag then disconnect the yellow connector under the dash on the same side and allow 15 minutes before attempting to work on that side.

Aug 18, 2014 | 2011 GMC Sierra 1500

1 Answer

Turn off passenger airbag


Always refer to your owners manual, but if there is no key switch in the glove box, you probably have the sensor system which monitors weight in the passenger seat. If you have more than 30lbs in the seat the airbag is "on" and the sensors are activated. Otherwise the passenger side is off if the seat is empty.

Jul 16, 2014 | 2006 GMC Sierra

1 Answer

How to disable passenger airbag in 2013 gmc yukon


Look in your owners manual

Maybe you can't, unless you can find it in the manual

Usually the occupied seat sensor, adjusts the passenger
air bag, based on weight

May have to ask at the dealer service dept & have the doctors
letter, to do anything about it

How I don't know,short of unplugging the air bag & installing a
test adapter, which is to work on the vehicles systems,not legal
to leave in the system

Apr 02, 2014 | 2013 GMC Yukon

1 Answer

Reset airbag module on 2002silveado


normally if a car has been in a bump and the air bags deployd a new air bag moduel is needed thats why it cannot be reset

Sep 26, 2012 | 2002 Chevrolet Silverado 2500HD

2 Answers

How do you get the air bag light off


do you have the airbag disabled on the passenger side? have you turned the key in the disable passenger side airbag. if the airbag is disabled then the light will stay on

Apr 14, 2012 | 2000 GMC Jimmy

2 Answers

Bmw 5 series 2.3L 2000 england how do i remove airbags from drivers side. i was told i would need a torx 30 to remove two bolts from behind steering wheel. my steering is a m5 wheel, and also how would...


to disable them,unplug the plugs after the battery has been disconnected for 2 minutes to avoid deployment. if you physically want to remove them,that is different,the one on the passenger side is part of the dash,a thin plastic line ruptures upon deployment and the airbag inflates.
the drivers airbag is disabled by the yellow connector at the bottom of the steering column

Jul 14, 2009 | 1999 BMW 323 Series

2 Answers

2000 Chevrolet Malibu LS airbag problems


The passenger side airbag is a lot easier then driver side. Take the glove box out and you will see two 10mm bolts holding it in place. When you open the passenger side front door, remove the panel on the side of the dash and you will see yellow connectors.The 1 closest to the front is attached to the air bag, it is clipped into the frame. Just pull it loose and take it out and your done. For the Driver side, it takes a skinny T27 to remove the two star bolts, then just disconnect the horn red clip and ground and install new airbag. The module is located under the passenger seat, underneath the carpet. Kinda stupid but thats where its at. You also need to replace the front impact sensor located behind the grille on the back side of the metal bar to each side. Follow the hood latch down. Also just to make sure, you know to disconnect the battery before you do all this. You don't want new airbags to accidentally deploy.

May 13, 2009 | 2000 Chevrolet Malibu

1 Answer

Remove d/s airbag


disconnect the battery, then find the air bag plug normally under the seat or around side of the seat, maybe under the carpet *bright orange cable*

once you have disconnected the battery and the cable start taking the steering wheel apart and remove it, after market steering wheel will be needed unless your just going to cut the air back out and re fit the wheel, do not connect the air bag cable, you will have a dash light on the dash for air bag doing this though.

Apr 10, 2009 | 2000 GMC Jimmy

Not finding what you are looking for?
2000 GMC Safari Logo

Related Topics:

118 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...