I change the carb its getting gas i think its the brain but want ti try the sensors first \
SOURCE: no power when hit the gas
The fuel presure should be at least 60- 66 psi key on engine off, and then drop some when started, if it doesn't go any higher than 50 psi that would explain your backfire concern. If it is low then the fuel pump is weak. I have also seen soot on the little wires inside the Mass Airflow Sensor cause a concern like this.
SOURCE: 94 gms safari van heater blower not working
This van has a resistor under hood for the blower motor and is the blower motor getting power to it
SOURCE: have an 88 Chevy c1500 305 Eng i want to change tbi to carburetor
2bbl intake will not fit 87-95 small blocks heads are diferent from pre 86.the center bolts on your manifold are angled different than the front and back bolts.your 2bbl manifold has the same angle bolts front to back.i converted my buddies 89 to carb,had to make adapter plate for carb.but to make a long story short there is a lot of power loss and fuel economy your better of with tbi.
SOURCE: 1987 chevy s10 2.5l tbi will not start. changed
That eliminates the crankshaft and camshaft position sensors. Have you checked the fuel injector itself for an open winding or stuck valve plunger? There should not be a steady 12 volts to the injector--if good injector, it would be spraying fuel steadily into the throttle body. But at least the engine should try to run if poorly. Take the injector out, dry it off with air, and intermittently apply 12 volts to one terminal while grounding the other. You should hear a click from inside every time you touch 12 volts. If not, replace it. If it does, it may be plugged with debris. Try blowing through it in reverse with compressed air.
SOURCE: 1987 chevy S10 engine idle problem
relace the throtle air idle valve.The temp switch will allso cause this problem.
67 views
Usually answered in minutes!
×