Question about 2000 Dodge Caravan

1 Answer

Heater sensor on 2000 grand caravan, how to replace it.

Blower only works on high speed.

Posted by on

  • rjv1015 Feb 01, 2009

    thank you, would you have any idea how to replace the resistor.



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 512 Answers

More than likely the blower motor resistor is bad

Posted on Feb 01, 2009

  • Russell Bailey Feb 01, 2009

    on a 2000 caravan the resistor is located under the hood on the passenger side close to the strut tower, under the cowl and wiper is held in by 2 5/16 screws

  • Stan Lee
    Stan Lee Dec 14, 2011

    on the 2000 SE, there are no screws. The assembly 'snaps' into the rectangular hole, and the only way to get it off - is to YANK it off!
    It IS located like Russell Bailey said below - passenger side under the hood, next to the strut tower on the back wall. It is a tan gray phenolic block with a black connector. Grab a hold of the edges and pry it off. There is no nice way of doing it!



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do I replace blower motor resistor?

U are on the right track. But check this out - is the low speed on the blower the only thing that is not working? Could be other things, such as lights that you are not aware of.

On some cars the low speeds for the blower work thru the ignition switch. If something is wrong with the switch the fan will work on high speed only but the lower speeds are inoperative.

Sep 05, 2015 | 2000 Dodge Grand Caravan

1 Answer

Heater on 2000 caravan runs on only high speed

Need to replace the blower motor resister.

Jan 23, 2010 | 2000 Dodge Caravan

1 Answer

Heater only works on high

there is a blower motor resistor mounted on the blower motor housing (rite next to the blower motor) replace this and your heat will function on all speeds.

Dec 31, 2009 | 2000 Dodge Caravan

1 Answer

The heater only works on high

There will be a blower motor resister very close to the blower motor,It will have 7 wires going to it,give,or take one.Also,it mounts with two screws.This is your speed control.Remove the resister,and replace it with a new one,available at auto parts house.

Oct 12, 2009 | 2001 Dodge Grand Caravan

1 Answer

Only High speed blower front on 01 dodge grand carvan

Sounds like you need to replace the Blower Motor Resistor. It is located on the bottom of the heater box about where the passengers left foot would rest, behind glove box. It has 2 screws holding it on.

Jun 08, 2009 | 2001 Dodge Grand Caravan

1 Answer

Heater fan will not shut off runs all the time on high speed. 03 dodge grand caravan

Sounds like resistor is faulty. I believe on that vehicle, look up under dash behind glove box, and you should see blower & the harness that runs from it to a resistor attached to housing/duct. Pull connector off to stop blower. Replace resistor.

Apr 19, 2009 | 2003 Dodge Grand Caravan AWD

2 Answers

Blower motor only works on high.

you can go to to subcribe to the factory manual, but you need the blower motor resistor, a dealer item. And typically its located by the blower mounted to the blower housing.

Jan 10, 2009 | 2002 Dodge Grand Caravan

3 Answers

Air conditioning only works on high - 2002 Grand Caravan

If you are looking for the fan blower resistor, it is located behind the glove box. No tools need to get to it and a nut driver to remove the 2 screws to replace it. A 20$ part. It has 2 sets of wires coming off of it. A do it yourself fix.

Dec 29, 2008 | 2002 Dodge Grand Caravan

1 Answer

2000 Dodge Caravan

if it is auto temp control the power module could be bad....if is regular style where you control blower speed the blower motor resister is bad

Oct 29, 2008 | 2000 Dodge Caravan

Not finding what you are looking for?
2000 Dodge Caravan Logo

180 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

79851 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides