Question about 1995 Chevrolet S-10 CA Edition

1 Answer

Wipers and radio quit

Wipers stop working at same time radio stops working and relay chaters at wiper motor if you turn the radio on chattering stops but wipers still doesn't work neither does the radio. sometimes it fixes itself for a few minutes then back to same old problem

Posted by on

  • hoperchest Feb 01, 2009

    i'll try thanks if it helps it all started with a dead battery after i replaced it the clock on the radio stays on and it will run the battery down in 4-5 days if truck is not started.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 33 Answers

The relay is over heating and internally shorting out.
Replace the relay.

Posted on Feb 01, 2009

  • richtko Feb 01, 2009

    I would take to the dealer to reset the radio. Some have a certain sequence to reprogram.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Monowiper works fine when in full wipe but when in intermittent wipe and park mode it stops 3 inches too high ??


It sounds like the wiper parking position relay has failed. You see, when you turn on the wiper a series of relays on the actuator side are energized and cause the wiper motor to turn on and move the mono-wiper through its arc.

When it reaches the maximum extent of its travel, the wiper circuitry then reverses the arms direction and it swings back. This goes on until you turn off the wipers by turning off the ignition key or turning off the power switch.

When you turn off the wipers, the parking circuitry is activated. The central feature of this part of the wiper circuitry is the parking position relay. As the wiper begins to de-energize the parking position relay is activated. The position relay ensures that the wiper returns gently to the same position each time you turn off the wipers.

If the parking position relay weren't there, the wipers would park wherever they stopped on the windshield. However, the relay circuitry charges when you hit the off button and ensures that the wiper arm sweeps down to the same spot each time. If it does not activate, the wiper arm stops as soon as you turn off the power, as noted. This means that the wiper might, one time, stop in the center of the windshield or it might stop all the way to the left of right.

Aside from its complete failure, manufacturers build in telltales that indicate when the circuit is about to go. One of them is the wiper blade's parked position. Normally, the position relay ensures that the de-energized wiper circuit settles gently to the bottom of the windshield, as noted. However, if the position relay is failing most manufacturers have it park some distance from the bottom of the windshield to give you a head's up that the relay is on its way out.

Since the wiper circuits are fairly involved, it is best to leave it to a trained professional to do the work. However, if you feel you have the expertise to do it, your first step is to obtain the serviced manual for your vehicle. The service manual will give you the step-by-step repair procedure.

Since all parts of the wiper circuitry are related be careful, if you are repairing it yourself, that you replace each component according to the instructions as you might damage something else inadvertently.

Nov 12, 2014 | Cars & Trucks

1 Answer

REAR WIPER ON 2007 CHEV UPLANDER QUIT WORKING. IS STUCK HALFWAY UP REAR WINDOW.


Your motor is more then likely locked up. Replace the wiper motor. First check the relays.

Oct 13, 2014 | 2007 Chevrolet Uplander

1 Answer

2009 Saturn Vue. Rear Wiper and Washer both stopped working at same time.


FUSE...RELAY...CIRCUIT BREAKER...OR WIRING! WITH REAR WIPER SQUITER SWITCH ENGAGED,,,CHECK FOR VOLTAGE AT HARNESS CONNECTOR

Feb 09, 2013 | 2009 Saturn VUE

1 Answer

Rear wiper works 3 times and quits motor works with aux power


does the rear wiper have a delay..?
turn it on and after it stops, leave it for at least a minute.
Some of these vehicles also have a moisture sensor so if the window is dry, the wiper will not operate until the sensor detects moisture.
You may also have a timing relay issue but the location of the relay is hard to determine as some have the relay under the dash while others mount it at the rear of the vehicle..

Mar 10, 2011 | Infiniti FX35 Cars & Trucks

2 Answers

1998 Ford expedition wiper I turn on and they no turn off until I turn off the truck and just turn all way up in hi and no work on low some time turn on when I turn the truck on I have to turn off and...


need to check the intermittin wiper relay and try unpluging the wire under the dash that go to the wiper switch if the wipers continue to go haywire then its the wiper relays themselves if they stop working all together its the switch inside

Jul 30, 2010 | Ford Expedition Cars & Trucks

1 Answer

Wipers won't stop wiping.


Sounds like your intermittent wiper circuit is defective. Normally the intermittent feature is engaged by one of the functions on the multi-function switch (usually on the steering column). The circuit of the intermittent wiper periodically activates a relay that closes across the "Wiper On" switch. Your intermittent wiper circuit is likely defective and holding its relay closed (or the relay is stuck closed), thereby keeping the wipers on. Note: The wiper motor has an internal switch that opens when the wipers are in the park position and that is designerd to stop the wipers in the park position. When you turn on the wipers (or the intermittent relay is closed), the motor's internal switch is shunted such that the wiper does not stop at the park point of the cycle.

Apr 27, 2009 | Ford Explorer Cars & Trucks

2 Answers

Intermitent rear wiper operation and sunroof issue.


Sorry I cant offer any soloution but I do have the Same Problem :( I know its a long time ago but did you find the answer to fix the problem? Would love to Know :)

Kind regards
Ian

Feb 26, 2009 | 1994 Land Rover Range Rover County

Not finding what you are looking for?
1995 Chevrolet S-10 CA Edition Logo

340 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

63572 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...