96 jeep cheroke classic
SOURCE: left rear turn signal and brake light dont work
You have a broken wire to the turn/brake light portion of the light as they use the same wire. Or where the plug goes into the light assy could be bad. Torsion mount lights are horrible and you should think about replacing with a universal light that you can wire direct.
SOURCE: 96 acura tl 3.2l is overheating+signals wont work
Start with the easy one (hopefully). You probably have to replace your turn signal flasher. It's located behind the dash, driver side of steering column in the relay block (just pull out to remove).
Your overheating problem: Are you losing coolant, or is the car just running hot? Any leaks, puddles?
Check the cooling fans to make sure they are kicking on as the engine temp rises. If not, you may have a bad switch that is not telling the fan to go on. If fan(s) are operating ok, check the thermostat. If it isn't opening properly, it could be the cause of the overheating. If you have a leak in the system, then when it gets too low, it starts to overheat. Many possibilities, So, let me know the answers to the above so I can help further if needed.
SOURCE: the hazard lights work, turn signals dont. jeep
On your model,there is a separate hazard relay to the turn signal relay.On the fuse block(right-hand side kickpanel just inside the r/hand door)the upper left relay is the turn signal relay.Bottom right is for the hazards.Hope this helps you.
123 views
Usually answered in minutes!
×