Question about 2003 Chrysler 300M

1 Answer

Roar from front above 20 mph

The inner right CV joint felt extremely loose. I replaced the axle and the noise remained unchanged. While the axle was out I noticed slight looseness from the spline coming from the transmission. There is very little, if any, change in the roar at highway speeds. Thanks in advance for your input on this problem. The car is a 2003 Chrysler 300M 3.5L with engine code G.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 218 Answers

Have you checked the wheel bearings in the front, there may be a possibility that the bad cv axle may have caused premature bearing failure and thats where you noise is coming from. Hope this helps.

Posted on Mar 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 Impala, strong right to left vibration felt in the front end ONLY when accelerating, NOT felt through steering wheel NOT felt when coasting, or slowing down, strait or turning vehicle tracks...


Has to be a drive axle,most likely an inner joint,should be able to feel the play if one is bad (jacked up to let the wheel spin freely).
Also. If the front suspension is weak,or lowered, the CV axle will bottom out in the inner plunge cup and make a terrible vibration.

Feb 02, 2011 | 2001 Chevrolet Impala

1 Answer

I have a very noisy front end at above 20 mph.


COULD BE YOUR CV JOINTS. TIRE GUY SHOULD HAVE SPOTTED. CHECK THE RUBBER BOOTS JUST BEHIND THE HUBS. CRACKED? TAKE TO DEALER

Mar 25, 2010 | 2004 Mitsubishi Endeavor

4 Answers

Honda Pilot 111,000 miles. Wheel or tire noise?


it can be any of the above, rotate the tires and see if the noise location seems to change, but the last thing i would suspect is the CV, they just click when turning, the wheel bearing is my choice here, they roar, tires make a diff noise.

Jan 29, 2010 | 2003 Honda Pilot

2 Answers

Growling noise from front of my taurus while driving, it also makes a whining noise when i steer hard left. i had the right front wheel bearing changed but the noise's are still there. also the inner cv...


It sounds like the CV joint, no they are not supposed to be loose, free to move but not loose like you describe, sort the CV then look at the wheel bearing as I imagine all the noises will disguise others

Jan 07, 2010 | 1997 Ford Taurus

1 Answer

"Humming" or "bearing" type noise in left front at highway speeds


That's a hub bearing. Replace the one that's doing it. I'm assuming this 'roar' is coming from the front, NOT the rear.

Jun 10, 2009 | 2001 Hyundai Elantra

1 Answer

2004 camry, vibration right front


If the wheel is in balance and there is no other signs of what is causing the vibration than yes that cv joint should be chk. Is the strut ok? might want to chk. that too.

May 31, 2009 | 1998 Toyota Camry

1 Answer

Noise w/front left tire when turning slightly right but NOT left


the grinding grating rattling annoying sound is yor axles (velocity joint) it could be a simple thing as the boot rubber poping out and the grease spilled off or the bearing is shelling. In any case have the joint repaired or replaced. After this you will need to align as the changing or removing of the joint messes the alignment up.

Apr 02, 2009 | 2001 Saturn S-Series

1 Answer

Right front CV joint broke


probly cant get it from a parts yard they will want too sell you the whole thing
go too the dealer ship or too e bay or jc whitney

Mar 31, 2009 | 2002 GMC Envoy

2 Answers

Inner cv joints


inner cv joints are the joints on the inner half of the axle shaftswhere they go into the transmission. sometimes the easiest thing to do is replace the axle shafts

Jan 05, 2009 | 1996 Chrysler LHS

Not finding what you are looking for?
2003 Chrysler 300M Logo

387 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...