Question about 2000 Isuzu Rodeo

1 Answer

Replace thermostat on isuzu axiom

What is the easiest way to get to the thermostat housing in a 2002 isuzu axiom. I tried removing water pump however it looks like it is located under the mainfold in the middle of engine.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

I just had a garage replace my thermostat on my 2002 Isuzu Axiom. The book calls for 2 hrs labor, no way. iI took the garage more like 5 hrs plus, they ate the additional 3 hrs of labor. Note, the intake manifold must be removed and even then special tools are needed because it is still buried deep down. The garage took pictures ot this one because of how ridiculours Isuzu designed the location.

Posted on Aug 20, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Goes do I get the rear wheel bearings off a 2003 Isuzu Axiom


quote
  1. Before servicing the vehicle, refer to the precautions section.
  2. Remove or disconnect the following:
    • Rear wheel
    • Disc brake caliper and bracket
    • Disc brake rotor
    • Wheel speed sensor bracket
    • Parking brake cable and bracket
    • Parking brake shoes
    • Axle shaft 4 and bearing housing 5
    • Snapring and discard it
    • Bearing, press it off the axle shaft with the bearing holder and oil seal. (you will need new seals)


26120462-bc3iup444wd3jyd1bmsomxey-2-0.jpg

Mar 06, 2016 | Isuzu Cars & Trucks

2 Answers

Isuzu axiom overheat


first make sure the fuse is not blown for the fan, if anybody has ever tried to repair it before make sure the wiring is not backwards making the fan run backwards, try a coolant flush.

Jan 18, 2013 | 2002 Isuzu Axiom

1 Answer

2002 isuzu axiom engine shuts off and will not start


I am also working on a 2002 isuzu axiom with the 3.5 engine that also starts for a few seconds then shuts off and will not start back up i did an engine over haul on it, and the engine ran before i removed the engine, did you find the problem?

Aug 07, 2012 | 2002 Isuzu Axiom

1 Answer

2002 Isuzu Axiom is running hot. No heat.


sounds like the thermostat is not opening up

Dec 19, 2011 | 2002 Isuzu Axiom

3 Answers

WHERE IS THE THERMOSTAT ON A 2002 GMC SIERRA 5.3 LITER


Check this...
  1. Remove the air inlet duct.
  2. Drain the cooling system.
  3. Remove the radiator outlet hose.
  4. Remove the thermostat housing bolts.
  5. Remove the thermostat from the water pump housing.
NOTE The O-ring seal is integral to the thermostat housing


zjlimited_208.jpg

Fig. Thermostat housing - 4.8L, 5.3L and 6.0L engines (clikc image for zoom)


Hope helps (remember to rate this answer).

Dec 10, 2010 | 2002 GMC Sierra

2 Answers

Where is the thermostat on a 2002 Chev. Cavalier with a 2.2 DOHC located?


Please see my tip at http://www.fixya.com/cars/r5929960-s_thermostat . These are generic instructions. Specific instructions from autozone.com for your car are pasted below. If you get stuck, please get back to me.

  1. If equipped with an automatic transmission, remove the exhaust manifold.
  2. Drain the cooling system.
  3. Remove the thermostat housing to water pump feed pipe bolts.
Remove the thermostat housing to water pump feed pipe.


jturcotte_257.gif


Fig. Remove the thermostat



  • Remove the thermostat.


  • To install:

    1. Install the thermostat.
    Install the thermostat housing to water pump feed pipe.
    jturcotte_258.gif

    Fig. Install the thermostat housing to water pump feed pipe


    1. Install the thermostat housing to water pump feed pipe bolt and tighten the thermostat housing to water pump feed pipe bolt to 89 lb inches (10 Nm).
    2. If equipped with an automatic transmission, install the exhaust manifold.
    3. Fill the cooling system.

    Nov 23, 2010 | 2002 Chevrolet Cavalier Coupe

    1 Answer

    WHERE IS THE THERMOSTAT,UP OR DOWN ON THE ENGINE.


    If you follow the top radiator hose to a domed alumillium housing, it's in that housing.

    Jul 15, 2009 | 2002 Isuzu Axiom

    2 Answers

    How to replace tail/stop light for a 2002 isuzu axiom


    remove the hardware (2 bolts) then wiggle to loosen, now pull outwards (pull somewhat hard) towards the sides to clear some kind of guide. Then towards the rear<

    Dec 16, 2008 | 2002 Isuzu Axiom

    Not finding what you are looking for?
    2000 Isuzu Rodeo Logo

    1,811 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Isuzu Experts

    yadayada
    yadayada

    Level 3 Expert

    70347 Answers

    Steve Hurc
    Steve Hurc

    Level 3 Expert

    450 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22041 Answers

    Are you an Isuzu Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...