Question about 1999 Volkswagen Passat

1 Answer

I need to know what size my engine is

The engine no is 038103373r it is a passat

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 840 Answers

Look in the engine compartment it should say top of motor if not check the the emissions label opn underside of hood/ Please rate my repsonse thank you vey much

Posted on Feb 01, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What type of fuel?


Do you know your model and engine size?
For 118TSI, it is petrol engine (1.8L).
For 130TDI, it is diesel engine (2.0L).
For V6 FSI, it is petrol engine (3.6L).

Apr 18, 2014 | 2007 Volkswagen Passat Sedan

1 Answer

Want to know if 2003 passat 1.8T automatic have the same size and length of drive shaft at the front left and right?


Yes, the same size and length of drive shaft at the left and right for 2003 VW Passat 1.8T automatic.

Jul 27, 2011 | Volkswagen Passat Cars & Trucks

1 Answer

Hand break light on constantly and giving out warning soundon passat


Usually means that ABS (automatic braking system) has failed, but could also be failure of
the switch that detects hand brake on/off.

Need year of mfr for your Passat, and exact model number & engine size.
8th and 10th digits of VIN will do.
8th digit = engine size
10th digit = model year

May 13, 2011 | Volkswagen Passat Cars & Trucks

1 Answer

Passat1999 P0506?


That can sometimes be attributed to an ignition coil. I would need to know your engine size and if there are any more codes to further help you. Good luck

Mar 27, 2011 | 1999 Volkswagen Passat

1 Answer

I need to know what the part that theoil filter attachestoisnamed


OIL FILTER MOUNT. TELL THE PARTS STORE GUY YOU NEED THE GASKET OR ON A VW IT MAG BE A O-RING FOR THE OIL FILTER MOUNT ON YEAR ,MONTH, ENGINE SIZE AND TYPE OF CAR

Jan 28, 2010 | 1991 Volkswagen Passat

1 Answer

What size are the speakers???


all 4 speakers at the door are 6 1/2 inch .Depending on the brand you pick will be the cost. good luck.

Jun 04, 2009 | 1999 Volkswagen Passat

1 Answer

I have a 2000 Passat and going to have my friend replace the rotors and breaks. I am preparing to fix it but want to know what sizes are the bolts for the calipers sliding pins. If you know the Bolt s


For a wrench or for the acctual bolt size.
To remove front pads..you need 8mm allen socket to pull the caliper guide pins, then 17 or 18mm..To remove rear pads...you need 13mm socket for lock bolt on guide pins and 15mm open end wrench (thin section to hold guide pin while you remove lock bolts..I ground down a spare wrench). You DO NOT have to remove rear carriers to change rotors..just remove lock screw and angle rotor out. The B5 Passats don't have the electronic parking brake so you don't need VAG Com to change pads.
Installation tips:
Clean and regrease the guide pins with "synthetic caliper grease"
Rear lock bolts come with preapplied thread locker and "are not to be reused"..I just wire brush the threads and use some Loctite Blue on em. I smear just a little antisieze on the inside bore of the rotors and on the lock screw threads to prevent corrosion and make next rotor change ez. Torques:
Front caliper guide pins:18 ft lb
Front carrier bolts: 89 ft lb
Rear guide pin lock bolts:26 ft lb
Wheel lugs: 89 ft lb

May 29, 2009 | 2000 Volkswagen Passat 4Motion

1 Answer

Engine sizE?


There ought to be a sticker with emissions related information on it under the hood. Typically the sticker has "This vehicle conforms to Federal emissions standards for **** year vehicles....." It should tell you the engine size as well. I hope this helps

Feb 20, 2009 | 1999 Volkswagen Passat

2 Answers

1993 VW Passat


remove top engine cover , and slacken oil filter top with an oil filter strap

Oct 06, 2008 | 1993 Volkswagen Passat

1 Answer

Engine swap


Generally it is not recommended using parts either that the ones designed for same model, however some Passat engine connects same way as Golf. You need to know the Passat engine year and verify engine mounting procedure and connections positions. Getting the two Haynes manuals for the two VW models can help you to compare.

Jul 06, 2008 | 1993 Volkswagen Passat

Not finding what you are looking for?
1999 Volkswagen Passat Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

yadayada
yadayada

Level 3 Expert

70387 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...