Question about 2001 Isuzu Rodeo

1 Answer

I have a 2001 Isuzu Rodeo I need to know how to check the transmission fluid in it ??

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 150 Answers

I have a 2001 Isuzu - cd3426a.gif

Posted on Feb 01, 2009

  • Brian032472
    Brian032472 Feb 01, 2009


    1. Park the vehicle on level ground and apply the parking brake firmly.
    2. Check fluid level with engine running at idle. NOTE: Be sure that transmission fluid temperature is below 30°C (86°F).
    3. Move the selector lever through all gear ranges.
    4. Move the selector lever to "Park".
    5. Let engine idle for 3 minutes and open the overfill screw (1).
    6. Add released transmission fluid until it flows out over the overfill screw opening.
    7. Let engine idle until a fluid temperature between 32°C (90°F) and 57°C (135°F) is reached, then close the overfill screw (1). Torque: 38 Nm (28 ft. lbs.) NOTE: Check transmission fluid temperature with scan tool.





    Minimum fluid level 57°C (135°F)
    Maximum fluid level 32°C (90°F)
    CAUTION: Do not open overfill screw with engine stopped.

  • Brian032472
    Brian032472 Feb 01, 2009




    picture

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What type fluid transmission Isuzu Rodeo 2001 (430LE)


no job stated, (top of, or overhaul or just drain and fill)???????
nice double post, only changed, character case. to Upper
what engine? size. btw, transmissions match engines (power)
what transmission?
manual or stick.?
USA rodeo, not Canada?
we are USA forum so....
ill guess, A/t for ATF fluid.
what to use, if car is still running, stock fluid, some are not.
ill read you the official service bull. TSB

4L30E/4L60E Transmission Fluid 2003 publ.

The correct fluid to use in all Isuzu vehicles equipped with the 4L30E or 4L60E automatic
transmissions is DEXRON®-III with a G-License Number (G-34318), Isuzu part number: 2-
90531-815-0 or equivalent (see figure 1).
When checking for correct fluid level, follow the procedures in the appropriate Workshop
Manual.
NOTE: Incorrect fluid or incorrect fluid level may cause shift complaints and/or transmission
damage.

that means use DEXRON VI now. DEX 6. what is seen on the shell NOW, 2016.
dex 3 is obsolete.


holds 18 pints, dry, fill
way less, simply drain in place. 6 pints falls out
if levels is ok now.
what you do measure what came out, drained and put back that exact amount.

Jun 22, 2016 | Isuzu Cars & Trucks

1 Answer

I have 2001 Isuzu rodeo 4 wd used don't have


Pull the transmission & rebuild it

Oct 04, 2014 | 2001 Isuzu Rodeo

1 Answer

How do we check the transmission fluid in our Isuzu Rodeo?


Best time to check your transmission fluid is....let it sit over night so it has time to cool down. In the morning start it up...Let it run for about 6 or 7....To warm up transmission fluid temp.
your transmission fluid temp should be about 100 to 125. you have to craw under your rodeo to your transmission plug...not your drain plug.....Take your plug out, If fluid drips, More then likely you don't need fluid....but use your fluid tube to add a little in...If it start to run back out, Your fluid level is good.

Jun 02, 2014 | 2000 Isuzu Rodeo

1 Answer

Where is the temperature light for my transmission fluid; I have a 2004 Isuzu Rodeo


There is no temperature light for your transmission fluid. Isuzu Rodeos are unique in the way that they have no dip stick or any way of checking your tranny fluid. You need to take it to a transmission specialist and they can drain all the fluid and replace it with new. It should cost around $180. Being low on transmission fluid can cause it to slip, eventually resulting in a blown transmission.

Feb 27, 2010 | 2004 Isuzu Rodeo

3 Answers

Eratic transmission shifting vibrates and slips when turning


It's low on transmission fluid! It has to be checked and pumped in from the bottom of pan. Check for leaks too.

Jun 30, 2009 | 2001 Isuzu Rodeo

1 Answer

Don't know how to check if the transmission fluid is low.


you need to crawl under it and look at the pan, there is two plugs on it. the lower one is for draining, and the one that sits up in a recess is how you check it. with it running and at operating temp, remove the check plug and fluid should drip out, if not you need to pump it in untill it does......

Jun 22, 2009 | 1996 Isuzu Rodeo

3 Answers

2001 Isuzu Rodeo transmission


under the truck you will see the large trans fluid pan. there are two 3/4 inch bolts. one recessed about 2 inches and one flush with the bottom of the pan.  The recessed one is the fill tube and the non recessed one is the drain.  You will need a pump of some sort to pump the fluid in the fill tube until it starts draining out.  I think if you start the truck the fluid will lower and you can put more fluid in until it drains again.  I dont know yet what kind of fluid to use.

Feb 01, 2009 | 2001 Isuzu Rodeo

1 Answer

2001 Isuzu Rodeo Sport will not go forward in drive


whats the fluid smell like? when was the last time it was serviced? where is fluid on stick when hot? low on fluid could do what you discribed, but chances are trans needs rebuilt. if fluid smells burnt, rebuild or replacement.

Jan 18, 2009 | 2004 Isuzu Rodeo

1 Answer

2001 Isuzu Rodeo stalls and shuts down when put in drive


  1. Remove the transmission oil drain screw and drain fluid.
  2. Tighten drain screw. Torque: 38 Nm (28 ft.lbs.)
  3. Remove the transmission overfill screw and fill transmission through overfill screw opening, using DEXRON III ATF. NOTE: Add transmission fluid until it flows out over the overfill screw opening.
  4. Let engine idle until a fluid temperature between 32°C (90°F) and 57°C (135°F) is reached.
  5. Add transmission fluid until it flows out over the overfill screw opening, then close the overfill screw. Torque: 38 Nm (28 ft.lbs.) NOTE: Check transmission fluid temperature with scan tool.


Chances are judging from what I've read about this transmission...
The fluid has probably never been changed unless you know it's been done.
My suspicion would be that the Torque Converter Lock-up Solenoid may be stuck in the "on" position causing your stall when you try to engage Drive.
This means the torque converter isn't allowing the slip you need to get into gear.
This may be a job for a transmission shop...
I hope this has helped.
Big Dan

Read more: http://www.justanswer.com/questions/1rchv-isuzu-rodeo-2000-80k-miles-shuts#ixzz0JPdd1OK4&C

Nov 22, 2008 | 2001 Isuzu Rodeo

2 Answers

How to check transmission fluid on 2001 isuzu rodeo


There is no dipstick on your auto trans. Checking it is a real PITA The trans pan has 2 plugs in it. The one on the very bottom is the drain. The one in the corner, up higher in a recess is the check/fill plug. To check, the engine must be warm and running, tranny in P. Remove the plug and fluid should dribble out. If it doesn't it's low, fill until it dribbles out, while engine is running. Obviously the truck must be on a lift or up on jackstands.

Nov 18, 2008 | 2001 Isuzu Rodeo

Not finding what you are looking for?
2001 Isuzu Rodeo Logo

Related Topics:

239 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...