Question about 1996 Volkswagen Jetta

1 Answer

How to install o2 senor on 1996 jetta

How do i install 02 senor on front bank on 1996 jetta

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 840 Answers

Get the o2 sensor off just use an open end wrench turn counterclockwise disconnect the connector and put the new one on ?please rate my respose thank you very much

Posted on Feb 01, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2000 navigator system too lean


Too Lean on which Bank of the Motor?

To have a lean O2 Code --you could have a rich fuel
condition & the pcm drove the fuel trim lean

Next you could have a vacuum leak-in the intake or exhaust system

Third you could have a failed O2 Sensor

Front or Upstream Oxygen Sensors get replaced at 100,000 miles

The front sensors are on the exhaust pipe between the motor &
the converter.

Will need a long handled flex head O2 Sensor Wrench

Mar 17, 2014 | 2000 Lincoln LS

1 Answer

P0420 Cat prob.or 02 senor


You won't know until you get both components checked out. A mechanic can measure the temp of the exhaust pipe before and after the cat to check it. The O2 sensors would need a scanner.

Jun 27, 2013 | Volkswagen Cars & Trucks

1 Answer

My Check Engine light came on, code reads bad O2 Sensor heat element Bank One Sensor One, This car have 2 front and 2 back O2 Senors, Is Bank one Sensor one on the Driver side or passenger side ? Thank...


bank 1 is the side cylinder 1 is on.sensor 1 is the first sensor in the exhaust on that bank from the manifold.cylinder 1 is the most forward cylinder on the motor when you look across the motor at the front of it to see which head/vlave cover is farthest forward.

Sep 18, 2011 | 1996 Lexus LS 400

1 Answer

Meaning of po146 code for 1996 chevy blazer check engine light


Code -P0146 - o2 circuit no activity detected,
Bank 1 senor 3
Bank 1 is going to be where number 1 cylinder is at,
It's going to be the very last o2 sensor on the exhaust pipe, check make sure it's connected, if it is more then likely bad sensor.

Jun 23, 2010 | 1997 Chevrolet Blazer

1 Answer

REPLACE BANK 2 o2 SENSORS 1996 CONTINENTAL


bank 1 and bank 2 refer to the positioning of the sensor on the car, bank 2 just means the second one, so if you start out at your exhaust manifold and inspect the piping going back, the second O2 senor you find will be the one you need to change, it will likely be around or near the catalitic convertor.

Mar 21, 2010 | 1996 Lincoln Continental

1 Answer

CODES P0134 AND P0135 ON 96 JETTA .CAR HAS NEUSPEED SUPERCHARGER THAT I INSTALLED CAR RUNS FINE EXCEPT CHECK ENGINE LIGHT KEEPS COMING ON.


P0134- O2 sensor Circ, bank 1, Sensor 1 no activity detected

P0135- O2 sensor heater circ, bank 1 sensor 1 malfunction

Dec 19, 2009 | 1996 Volkswagen Jetta

1 Answer

Po102 mass or volume air flow circuit low input


did it have the same code before you change the 02 sensor .cause it should of been po135 for an 02 sensor 1 bank .the mass is the one in the air breather

Feb 16, 2009 | 1996 Volkswagen Jetta

1 Answer

Finding out where the 02 sensor is located on a 1996 jetta


There are two places it could be. Either on the exhaust manifold with between one and four wires or on the catalytic converter.

Feb 01, 2009 | 1996 Volkswagen Jetta

1 Answer

Eng check lite


weird. usually an intermitent problem like that for are o2 sensor means that your catalytic converter is starting to cause problems but that should only set a code for sensor 2 not both sensors. sorry i cant be more help

Oct 21, 2008 | 2001 Mitsubishi Montero

Not finding what you are looking for?
1996 Volkswagen Jetta Logo

Related Topics:

157 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

yadayada
yadayada

Level 3 Expert

63572 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...