Question about 1997 GMC Jimmy

1 Answer

No blinking signal

Blinkers wont flash

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 195 Answers

Hello;
The turn signal flasher has probably gone out. Do your 4 way emergency flashers work? If they do, turn them on and that will activate your good flasher. It will be a round tin can shaped object located under the dash on the drivers side. Next to it or near it on the same junction block will be the turn signal flasher. They look the same. Pull it out and replace it with a new one.
Hope this helps. Please rate me highly.
Thanks;
Rich
RPM Northwest

Posted on Feb 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Turn signal blinking fast. Why would it do this?


If the dash signal is blinking fast and the back of car signal is NOT working, then the problem is the bulb in the back of the car. The one that is not blinking needs to be replaced. The bulb that's not blinking is burned out, and this changes the resistance of the blinker circuit causing the blinker to flash rapidly on the dash indicator. FIX: Replace the burned out bulb in the back of the vehicle.

Note - Sometimes this situation causes the blinker module on the fuse panel to permanently change to a rapid or even a non-blinking state. In this case you must also replace the blinker device itself, which is on the fuse panel and looks like a small cylinder (or cube) less than one inch in diameter.
25872306-0gjnqcgakvlfffn2os0snv0o-4-2.jpg

25872306-0gjnqcgakvlfffn2os0snv0o-4-8.jpg

25872306-0gjnqcgakvlfffn2os0snv0o-4-3.png

Sep 19, 2015 | 2002 Toyota Camry

1 Answer

Blinkers wont blink change the relay fuses ok


What about the turn signal switch on the steering column? Did you use a testlight and check voltage at the turn signal fuse? Goes hot when you turn on the key.

A lot of times, it's the turn switch or wiring in the steering column, but, It don't hurt to check the basics.

Feb 20, 2015 | 1999 Oldsmobile 88

3 Answers

How do I fix a blinker that is blinking erratically?


http://www.wikihow.com/Fix-Grand-Am-Turn-Signals You can try this , if you don't want to fool with it, spend $40-$50 and replace multi-funtion switch

Oct 05, 2014 | 2001 Pontiac Grand Am SE

1 Answer

Turn signals blin continually


There is only a few things that can cause blinkers to blink continually, meaning if your saying they wont shut off, Normally it is the blinker flasher or a fuse. Sometimes it can be in the blinker switch itself. I first would check the flasher, and turn signl fuse. If the blinker stays on and does not flash, still can be bad flasher or fuse or a ground problem, You would then have to check the wires around area where there contact to the tail light blinkers and front blinkers. But first start as said earlier with checking flasher fuse, switch and fuse. Mike

Jan 16, 2012 | 1995 Cadillac DeVille

2 Answers

Right rear turn signal blinker blinks very fast


Your right rear turn signal bulb is blown.Replace the bulb and the fast blinking will stop.

Nov 26, 2011 | 1999 GMC Suburban

2 Answers

The blinker goes on but does not flash! What should we look for?


Did you check your turning signal lights are on (and not blinking)? It is normally a sign that one of your turning signal lights is burnt out. But if both are lite and not blinking then it is a blinker relay.

Jun 07, 2011 | 1999 Oldsmobile Alero

1 Answer

TURN SIGNAL ON MY 1994 PONTIAC BONNEVILLE WONT BLINK


the turn signal flasher is located under the dash, driver side, on steering column

May 20, 2009 | 1994 Pontiac Bonneville

3 Answers

Turn signal wont flash is not blinking


If you mean autozone sold you a socket looking thing, that's possibly a relay? That doesn't go in the fuse panel area. If you have your manual there should be a diagram of the relays. I don't have the same vehicle, but the relays are just above and to the left of my brake pedal. I could be wrong and what you have is not a relay, but not blinking could be a blinker relay problem.

May 20, 2009 | 1994 Pontiac Bonneville

1 Answer

Right read blinker/break light dont work, turn signal blinks rapidly


It's the bulb. There are two filliments in the bulb. One is for when you turn your lights on and the other is for breaking and blinker flashing. When the break filliment goes bad it causes the blinker to flash very rapidly. 100% the bulb. Change it and all will be good again. P.S. if it were a fuse none of the break lights or blinkers would work.

Apr 20, 2009 | 2005 Ford Explorer

Not finding what you are looking for?
1997 GMC Jimmy Logo

Related Topics:

144 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...