Question about 1992 Chevrolet Lumina

2 Answers

I need to replace the crank sensor on my 1992 chevy lumina the only problem is i cannot get the old crank sensor off

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

If the sensor is located back at the firewall I know what you are going threw.Beleve it or not the easyst way is to drive old sensor down into the engine this willnot harm the engine I have done this for years.Inside of the oil pan there is a seporater plate the old part willnot make it to the crank.

Posted on Mar 18, 2013

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 11,896 Answers

AFTER SOAKING SEVERAL TIMES WITH A CAN OF "KNOCK IT LOOSE" or something better than WD, then

  • Disconnect the wiring harness.
  • Unbolt the sensor mounting bolt.

Posted on Jan 31, 2009

2 Suggested Answers

  • 2920 Answers

SOURCE: need to replace crank sensor, cant get it off to replace it

sometimes they have to be drilled out so you can replace them

Posted on Jan 31, 2009

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My 1992 Chevy Lumina euro 3.1 liter engine will not start check the spark plugs for spark and there was no spark what is my problem


Hi, you probably have a bad spark pack. If I remember correctly, there is a spark pack for two spark plugs so three total.

Jan 24, 2015 | 1992 Chevrolet Lumina

1 Answer

1992 Chevy Lumina euro 3.1 liter enginecar has been running and runs real well every now and then you wont to start. I spray starting fluid in it and it starts runs real well this is happen about 10 times...


its and old car, and id bet never once tuned up in last decade.
did i guess right?
no spark, well, it takes spark at all cylinders not 1.
is spark good out of coil to distributor top?

if not, then we insert the diagnostic jumper to the DLC port
OBD1 ECU, back in 92. (old systems)
then crank for 5 seconds
then release key
then watch the ECU tell you why it fails to make sparks.

the cmp sensor instigates spark. think of dummer boy in band
then the ECU sees that and creates all spark.
via the IGNITOR, the IGNitor charges the spark coil and BAM
spark , if the cmp (sensor) or ignitor fails the ecu sees that
and reports it, all you do is LOOK.


Jan 24, 2015 | 1992 Chevrolet Lumina

1 Answer

Where is the cranking sensor located on a apv lumina 1992 mini van


The 1992 Lumina APV does not have a crankshaft position sensor. If your car has a tachometer in the instrument panel it gets it's "signal" from the ignition coil.

Jan 25, 2011 | 1992 Chevrolet Lumina APV

1 Answer

On my 1992 chevy lumina neither one of the cooling fans will come on


Make sure the fuse is not blown,or cooling fan relays are not bad.Then check the cooling system to make sure the system is full.If it is low,the coolant sensor will not sense anything,it has to be emerged in coolant to sense.If all this checks out,replace the coolant sensor,for this sensor,is the most likely cause for the problem.

Dec 13, 2009 | 1992 Chevrolet Lumina

3 Answers

I have a 1992 chevy lumina z34, its not getting fuel to the injectors or the injectors or opening. I have fuel pressure. up to where you check for pressure on the fuel rail. it just died when I was driving...


Have you checked that engine oil level is okay, if so check that oil pressure switch is good. The switch is usually bypassed to start the engine, but it won't run with no oil pressure indicated...hope this helps

Oct 07, 2009 | 1992 Chevrolet Lumina

1 Answer

Runs Great, Won't start after turning off ignition


I would suspect the crank angle sensor 'CAS' this can be checked by the fault codes 

Sep 18, 2009 | 1992 Chevrolet Lumina

1 Answer

93 chevy lumina crank sensor location


front of engine just about 11:00 over crank pullry

Jun 12, 2009 | 1988 Chevrolet Corsica

1 Answer

Need to replace crank sensor, cant get it off to replace it


sometimes they have to be drilled out so you can replace them

Jan 31, 2009 | 1992 Chevrolet Lumina

Not finding what you are looking for?
1992 Chevrolet Lumina Logo

218 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...