The door automatically lock at 15 mph. Is there a way to disable this?
SOURCE: 98 Jeep Grand Cherokee Power Door Lock Problem
I have a 1996 Grand Cherokee - the same problem, except my interior lights flash on and off at the same time. Did you get your problem solved?
SOURCE: 2000 Jeep Grand Cherokee Laredo Door Locks Dont' Work Correctly
you need to check wiring between lf door and body..peel back rubber boot and pull on wires..you will find 1 or more broken wires..can be repaired
SOURCE: 94 jeep grand cherokee laredo v8 5.2l automatic.
You can check fluid level by removing the rubber plug in the cover. Fluid is full when on level ground, it is just at the edge of the hole (or very close) if you are already getting noises out of there, you can remove the cover and inspect gears for wear or breakage. If you find a large amount of metal debris in the lube it tells you something bad is going on back there. Although rebuildable, it's not a home job...requires exact settings in order to operate properly. You can find good units far cheaper than even a gearset costs in any scrapyard. to match ratio, count the teeth on the ring gear and the pinion gear. the replacement MUST have the exact same number. Before swapping diffs, check all back there to make sure noise is not from somewhere else.
SOURCE: auto door locks and interior lights flashing off and on continuesly
try to get yourself haynes repair manual book no: 50010
covers the jeep cherokee in great detail
SOURCE: Doors automatically lock
This cannot be done. That is the type security it comes with. Except you wanna remove it totally.
Cheers.
Unlock all of the Jeep Grand Cherokee's doors and open the driver's side door. Keeping the door open, lock it using the manual lock on the door itself.
Put the manual key into the ignition and switch it to the "On" or "Run" position, whichever applicable, without starting the engine.
Control any distant PC remotely. Test the Software now for Free!
www.TeamViewer.com/Remote_Control
Point the remote at the receiver (located by the little bulb on the car ceiling) and hold down the "Lock" button for up to 5 seconds.
When the driver's side door unlocks, you know the remote has been programmed correctly. If you are only programming one remote, jump to the next step. If not, manually re-lock the driver's side door and repeat steps 5 and 6 using each remote you would like to program and then continue.
Turn the key to the "Off" position and turn the ignition on immediately. This must be done within 20 seconds of programming the last remote. You're finished!
1,711 views
Usually answered in minutes!
Hey Jerome. I use this vehicle for working in the field. I am always needing to open the rear of back door for specific tools of my trade. It\'s a pain when I need to open one of these doors and they are locked. I am 60 yrs old and no kids ever ride in this vehicle. Thanks for the response. Barry
×