I have a 2002 Honda Accord that the driver side power window is about 2" down. When you push the power window button the window will go up about 1/2" or down about 1/2" but will not go any further in either direction. Any ideas about what to look for as the potential problem? How do I fix this?
An expert who has achieved level 3 by getting 1000 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert whose answer got voted for 100 times.
Re: 2002 Honda Accord Power Window
Since its moving a litle up or down this shows that there is power (current) to the motor ,
you will have to remove the door cover and check for any obstruction to the mechanism of the window...its channels and the rollers on the bottom of the door glass is in place or if theres some rust or it may have even rusted ...the base plate which holds the door glass and has the roller slide guide there!
Best thing it to open and examine !
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
CarGurusOct 9, 2012 - Power Windows not working - I have a 2006 Honda Accord and thepassenger and back power windows quit working all at once. ... My key less entry doesn't work either after I replaced the master Window control unit. 6 out of ...
Hi, the reason you hear the motor running but the window wont go back up is because the window regulator is bad. you will need to go to a parts store and get a replacement. you can get a replacement at Advance Auto Parts for $72.99. the part number is 741-766.
try going to a junk yard your motor was fine but your controls are not buy the controls and change them hondas do this when the resistance is burned out Junk Yard is the best place to find something simple as this 2 screws 3 plugs basic plug in play deal
you most likely have a power/ground/switch issue in the drivers door. the power for the other three doors must first travel through the switches in the driver door before it goes to the passengers. hence the reason why when somebody rolls down a passenger window and you push the up button on the driver door the window stops moving. the wires can break inside the rubber boot in the door jam. you can also have an internal problem with the driver door switch unit. you would need a wiring diagram to diagnose this concern.
1. Start the car and leave it idle. 2. Hold the window button down all the way, until the window is completely down.
3. Let go and push it down again and hold the window button for 2 to 3
seconds then let go. (You should be able to hear or feel (very faintly)
the motor/sensor reset.) 4. Pull up on the window button and roll the window up until it is all the way up, when it is up let go. 5. Pull the button up again for 2 to 3 seconds. (You should be able to hear or feel (very faintly) the motor/sensor reset.)
I wouls suspect you have either a inoperative window regulator (the frame work for the power glass) or a bad power window motor. More often then not the are sold as a single assembly and are not very hard to replace on this vehice.