Question about 2005 Ford F 250 Super Duty

1 Answer

Engine will not start

I just turned the engine off and when I tried to turn it back on it turns over but will not start

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 24 Answers

If it is gas it may be flooded, so when you roll it over put the gas pedal to the floor as far as it will go if it is fuel injected. If you do this it will stop the gas flowing to the engine until you get it started.

Brandon Bird

Posted on Jan 31, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Occasionally, about every 6 to 8 times tried, the engine will turn but not start. If I turn the key off for about 3 seconds, it usually starts within a few turns. Do you know what can cause this?

A year, make, model, and engine size would help but I will through this at you.

Instead of just trying to start the car turn the key to the run position and wait 3 seconds. Turn the key off and immediately turn the key back to the run position and wait another 3 seconds. Turn the key off then try to start. Do this every time you try to start the car. If you symptom never occurs when you start the vehicle like this than I would suggest taking a closer look at the fuel system.

Oct 10, 2016 | Cars & Trucks

1 Answer

Renault problems megane

try ignition on , dont start engine, press the button on the end of wiper stalk and hold until the speedo and rev needles start sweeping ,wait until they've completed the self test , about 90-120 secs then turn ign off and then start engine and lower roof down then back up

May 03, 2014 | 1999 Renault Megane

1 Answer

Battery died on my 2009 mini base model, replaced the battery and the seat belt/air bag light has come on. Took it to a mechanic and tried to reset...did not work. Now faced with a substantial charge for...

Something you can try is resetting your engine control module via your ignition.... Take and disconnect your battery for say 20 to 30 minutes....Reconnect your battery, turn key to on position, do not start your engine, turn key off, turn back to on position after about 5 minutes, turn back off, Start engine, in some models this is a reset for the engine control module.. Hope it helps.....

Jan 22, 2014 | Mini Cooper Cars & Trucks

1 Answer

Why wont my car start even after i tried the security reset. i turned key to on position for 10 minutes turned it off then tried to start it 3 times. security light still flashes

turn the key on and wait till the security light stops flashing ( this could take as long as 30 minuets ) then turn the key off then back on but do not try to start the engine and wait till the security light stops flashing ( again this could take as long as 30 minuets ) then turn key off then turn key on and start engine.

Jan 31, 2011 | 1996 Buick Regal Olympic Gold

1 Answer

Car wont start its clunking not turning over

You could have several things wrong with it. first loosen or remove the belt off the front of the engine.then see if it turn over. If it does then your a/c compressor is locked up, you'll have to replace it. If it doesn't hit the starter several times or as some one tries to start it with a hammer or some sort of steel rod. If it tries to start or turn then replace the starter. If it still won't turn the engine may be locked up. you can get a socket on the bolt that holds the balancer pulley on(at the bottom front of the engine) And try to turn it, turn it both ways usually when an engine locks up it will turn one way but not the other. If it turns both ways smoothly then go back to the starter it is probably locked up. Good luck

Nov 10, 2010 | 2002 Jaguar X-Type

1 Answer

Vehicle will not start

check for fuel and spark

Apr 16, 2009 | Jeep Liberty Cars & Trucks

1 Answer

Won't Start...Security Light On

Try this! Turn key all on (but notrunning) for 30mins., turn off then back on for 10mins., turn off and then back on for 10mins. turn off and then try starting engine. sounds like security system burnt up. may have to replace it.

Dec 01, 2008 | 2000 Chevrolet Astro

4 Answers

Car shakes when trying to start and doesn't turn over

  1. hold gas pedal to floor while trying to start. do not pump pedal.
  2. holding pedal to floor is how you start a flooded f.i. engine

Nov 12, 2008 | 2000 Lincoln LS

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers


Level 3 Expert

5575 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides