SOURCE: 1991 honda civic starter removal
Always start by disconnecting the battery when working with electrical parts on a vehicle. Once that is done then unplug the starter and unbolt the nut under the rubber boot which should be either 8mm or 10mm bolt, i can't remember which. Then next there will be two long 12mm or 14mm bolts holding the starter to the trans...remove them and the starter should lift right out. For installation just do the same but reverse and don't forget the metal gasket and i recommend putting di-electric grease on the electrical connections to keep those in good working order. Good luck
SOURCE: 1995 Honda Civic 5 speed manual will not shift
It could be that your syncro for the reverse gear is gone. Which would have to be brought to a tranny shop not a do it your self type of job.
SOURCE: 1990 honda civic lx 5 speed manual trans - clutch falls
On the firewall next to the naster cylinder there should be a reservoir for the clutch. Make sure it is full of brake fluid. If it is low then you may have a leak. If you fill it up and it doesn't fix the problem, then the slave cylinder must be bled. Good luck
SOURCE: HONDA CIVIC 1996 PULSING IDLE
It might be bad gas or a plugged filter or it might be a bad mass airflow sensor.
56 views
Usually answered in minutes!
iv put a new rotoerbuttin and the first two plugs wen you take the plug wires off the first two cylinders it still runs so its only runnin on one cylinder
here is how iit firing
here is how iit firing
×