Question about 2004 Nissan Titan

1 Answer

Seat belt release

Truck in front end collision, seat belt is locked down ,cannot release in order to use, already got one ticket for no use of belt help

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 840 Answers

You nee to replace the seat buckle and possible the tensioner/ the seat belt buckle is easy to replace its a torx screw 32 bit take it out and replace /disconnect the battery when removeing/ to check seat belt tensioner pull out see if it goes back like a yoyo and if it does then you may not need the tensioner/ Please rate my response Thank you

Posted on Jan 31, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I fix a locked seat belt after and accident


You should not try really. A seatbelt should be replaced after an accident like that.
.

Apr 22, 2016 | Cars & Trucks

2 Answers

How do I release a stuck new seat belt retractor?


You are probably pulling belt at the wrong angle and it won't release. Pull with easy steady tension, trying a different angles and it should come free for you. If it doesn't, then take it back to SEAT or VW, they can show you in 1 minute how to free it. Since it's a mandatory safety device, there should be no charge unless it requires replacement.

Apr 04, 2015 | Seat Cars & Trucks

1 Answer

Pt cruiser stuck middle seat belt


The problem:
The set belt stop has been lost so the seat belt retracts too far when the seat is laid flat. When laid flat the release mechanism lock as it should when not level. So the seat cannot be raised up as the belt is too tight and locked.
The Solution:
1) Push the two little clips to release and remove the headrests.
Pull the grey lever on the right of the seat base, lift seat base up and forward toward the front seat..
2) See two red capped leversat the back of the two seat hinges and lever them to the upward position, this releases the seat.
Rock the very heavy seat unit upwards and lift complete unit upwards.
3) Take it out of the car and turn 180% so that the back of the seat and base are in the upward position and the seat belt will pull out as it should
4) Replace the missing belt locking stop (I used a tie pin permanently fixed using super glue).
5) Fold seat back down and test then either re-fit seat unit or leave out to decrease fuel consumption..

db820222-7ca5-4d7b-8740-b685efc61b17.jpg


0fbf0c49-1712-4359-86dd-ee255a836cfe.jpg


b971a90e-fe2b-4599-ac59-f7dc0a5bba30.jpg

Aug 02, 2012 | Chrysler PT Cruiser Cars & Trucks

1 Answer

Rear seat belt is stuck in recline position. I recline the rear seat to make room and I can not raise the seat back up. The seat belt is not allowing the seat to raise


The problem:
The set belt stop has been lost so the seat belt retracts too far when the seat is laid flat. When laid flat the release mechanism lock as it should when not level. So the seat cannot be raised up as the belt is too tight and locked.
The Solution:
1) Push the two little clips to release and remove the headrests.
Pull the grey lever on the right of the seat base, lift seat base up and forward toward the front seat..
2) See two red capped leversat the back of the two seat hinges and lever them to the upward position, this releases the seat.
Rock the very heavy seat unit upwards and lift complete unit upwards.
3) Take it out of the car and turn 180% so that the back of the seat and base are in the upward position and the seat belt will pull out as it should
4) Replace the missing belt locking stop (I used a tie pin permanently fixed using super glue).
5) Fold seat back down and test then either re-fit seat unit or leave out to decrease fuel consumption.. 2_5_2014_8_03_56_pm.jpg 5f6d2b58-2927-4184-9c82-d111e3a9591a.jpg e9f641fc-5fbc-4c21-a371-ff371d942b1a.jpg a357ac71-d6ed-4dc7-999c-04367d3d6e72.jpg

Oct 26, 2010 | 2002 Chrysler PT Cruiser

1 Answer

Stuck seat belt


Remove the panels to the belt, normally these can miss roll and get stuck. Unbolt the unit so you can get some slack that should be enough to release and pull it back out to correct it. If that will not do it get a replacement from a junkyard and replace.

May 20, 2010 | 1990 Pontiac Grand Prix

2 Answers

Locked seatbelt in 2001 Ford F150


it is not recommended that seat belts from a collision be reused as they and the linkage have already been stressed and could fail in another collision, best to replace them with new, this i got from a collission expert

Dec 07, 2009 | 2004 Ford F150

1 Answer

2005 BEEN IN ACCIDENT AND NOW THE SEAT BELTS WILL NOT RELEASE


the seat belts will not release, and the air bag light is on
You will need to replace the seat belts that have the air bag wiring hooked up to them, they are supposed to lock in place during a collision.
there is no way around it.

Aug 07, 2009 | 2005 Chevrolet Aveo

2 Answers

Rear seat down and wont go back up; locked middle belt


middle seat belt shouldn't have anything to do with it. The seat locks down for stowage in the rear cargo area. you can pull the release handle on the back of the seat to release it back into the up position.

Jul 01, 2009 | 2006 Saturn Vue

1 Answer

Ford Focus seatbelt locked


There is a gas cylinder that tightens the belt in a minor collision, it is a one time use part it is independent of the air bag deployment system, you will have to replace the seat belt gas cylinder, that may mean a new belt assembly, not sure on focus.

Aug 22, 2008 | 2001 Ford Focus

1 Answer

My rear seat belts have locked with the seat in the down position and i can not put the seat back up


I had a problem like this. The seat belt stop (the small button through the belt) had broken and fallen off. When I tried put the seat up the belt had wound too tight and with no slack wouldn't release. I had to unbolt the bottom end of the seat belt from the floor and raise the seat. While I had the unit off the floor I had slack enough to release the belt and extend it to bolt the floor unit back down. There should be two of these button on the belt. One keeps the belt from rewinding too far and the other one holds the seat belt latch up on the belt. You can buy these buttons from some auto parts stores. You might have to buy a bag full, but they're not expensive. Good luck..

Aug 12, 2008 | 2001 Volvo V70

Not finding what you are looking for?
2004 Nissan Titan Logo

534 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...