Question about 2004 Chevrolet Aveo

1 Answer

Squeeky noise from belts when i drive

2000 chevy blazer

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Belt maybe dry tri spraying a little belt dressing on the belt start it before you start to spray the belt with the spray

Posted on Jan 31, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Will a 1996 chevy blazer LS 4wd differential fit into a 2000 chevy blazer LS rwd rear end ?


Measure the lenth of both rear ends. see iss all hardware will bolt up without fabrication. if its the same size it will work. But im afraid being a 4 wheel drive it will be geared lower then a regular pick up/ Drive shaft may work but if not it would have to be shortened or lenghthebed. alot of work. Brakes you could leave the non drum breaks on better stopping power. I honestly believe you would be better off just going to a scrap yard and find one very easy to remove and replave few hour job.

May 20, 2018 | Chevrolet Cars & Trucks

1 Answer

Hello i have a 2000 chevy blazer 4x4 has a growling noise gets louder the faster you go no change when you put in four wheel drive.put new hub bearing in no change.what do i try next.when i drive it drive...


ok does noise change when turning left or right if not its not a wheel bearing next try putting in neutral at 55 does noise change what you are looking for these is pinion and carrier bearings in differential the noise can be coming from several places have you checked all your fluid levels front and rear diffs and transfer case also check fluid condition also check for metal in fluids if you stick finger or paper towel in and if you see metal you will know where your noise is coming from

Sep 19, 2014 | 2000 Chevrolet Blazer

2 Answers

Squeeky fan belt noise after driving a little


It sounds as if the belt is dry. Belts dry out after a certain amount of time and then start to make chirping noises. If the belt is not badly cracked, you can try using a belt lubricant spray. These sprays usually only last for a short period of time, though.

Mar 27, 2014 | 2003 Fiat Siena

1 Answer

Loud clicking noise from front end of 2000 chevy blazer 4x4


Is the clicking noise most prevalent when turning close to full lock?
If so, then check your front drive shafts. It could be that their joints are heavily worn.

If not, then please describe when the clicking noise is most prevalent.

Nov 03, 2012 | 2000 Chevrolet Blazer

1 Answer

2000 chevy blazer passenger front wheel noise


driving in 4wd on hard surfaces produces what is known as torque wind up as the wheels cannot slip so the variations of distance going around corners , dips in the road etc place considerable strain on the transmission , transfer case , drive lines and diffs
that is why it is difficult to get out of 4wd unless you drive with 2 wheels on a grass verge to relieve that torque wind up
as for the noise check wheel bearings and the cv ("U") joint at that wheel as there appears a proble where the dog teeth in the hub are not engaging properly or are jumping out of engagement

Mar 26, 2017 | 2000 Chevrolet Blazer

1 Answer

1997 chevy blazer,serpentine belt making noise. belt dressing doesn't seem to help,sometimes it makes the noise louder.and then after driving for a good while the noise stops.; it starts again whe i...


May be a worn belt or a pulley whose bearings are shot. Remove belt and check it for the ribs having broken down or missing parts of belt. While it's off, check all your pulleys for turning freely, alternator, tensioner pulley, a/c compressor, PS pulley...If you hear any noise when spinning them, or feel any movement like wobbling, or if they have a rough feel, then its likely that pulley needs replacing.

Oct 17, 2011 | 1997 Chevrolet Blazer

1 Answer

Vibration NOISE in front end of 2000 Chevy Blazer. Any suggestions??


Check the front wheel bearings .... very common . While driving turn the wheel gently from side to side and see if the noise changes .. this will load and unload the bearings.

Feb 12, 2011 | 2000 Chevrolet Blazer

Not finding what you are looking for?
2004 Chevrolet Aveo Logo

Related Topics:

92 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...