Question about 1999 Ford Crown Victoria

1 Answer

Output seal leak - 1999 Ford Crown Victoria

Posted by on

  • flyfitkinkfl Jan 31, 2009

    my bad i trying to figure out how to use this site.. anyways i have a leak from the transmission output seal,, i replaced it but its still leaking, the slip yoke has a play from the housing, i dont think thats normal??

  • Ronnie Wilson May 11, 2010

    output seal leak ?? Do Not Understand, is this Transmission OUPUT SHAFT Seal Leak or What? Please Help me Help You


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 1,596 Answers

Ok Gotcha here we go

  1. Output Shaft has A Brass Bushing in tail shaft housing that supposed to minimize that Play the clearances vary but you R right Shouldn't be a lot of UP-DOWN Play look in to that.
  2. As for the Seal if it got Bent & or the Spring inside it Poped out it Will not Seal
  3. Also If the Yoke Sah A WEAR Channel on it that will Leak Im not sure if they make a SPEEDY SLEVE for yokes or not they do fof HArmonic Ballancers and many other Apps.
  4. Otherwise make sure you have the right seal Look for Part # with a Magnifing Glass the # is on the outside Lip of the seal Strange but TRUE
  5. Again I cant Stress Enough that it HAS TO GO ON STRAIGHT
  6. Also Look for Cracke at the back of thae tail shaft Housing Because if the YOKE is TOO TOO Loose that drive shaft WILL Beat the Seal & Housing into Submision
Other than that It Cant be much more than that . I realy Hope this helps and you can get it takin care of through this, If it Helps PLEASE RATE Me FAIF for this

Posted on Jan 31, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1995 passport troubleshoot slow leak in manual transmission

There is a seal on the input and output shaft and a seal on the top cover . A slow leak will have road dirt collecting on the leaking area. An input shaft leak will in time foul the clutch disk. An output seal will cause the drive shaft to be wet where it connects to the transmission.

Oct 22, 2016 | 1995 Honda Passport

1 Answer

Why would the left side output shaft keep leaking after repced 3 timeson 1994 saturn sl2

There is a bearing or bushing that is possibly worn out or there is a groove worn in the axle shaft where the seal rides. Have any other parts been replaced.

May 01, 2016 | Saturn Cars & Trucks

2 Answers

Do i need a special tool to remove the transmission seal on a 2002 kia sportage?

Which Seal?

Have you gotten under & checked the driveaxle seals?

The big leak will be the torque converter pump seal
That requires removing the transxale

Sort of old to do that & not rebuild the trans while your at it

May 16, 2014 | 2001 Kia Sportage

1 Answer

What causes transmission fluid to leak out. while it is seating.

where is it leaking front seal ****** pan or dipstick tube the driveline seal or (rear output seal ) or pump gasket any of those places can leak. when it cools down the seals are probably shrinking and alowing fluid to pass

Jul 22, 2012 | Dodge Ram Cars & Trucks

1 Answer

Leaking oil on rear driver's side wheel. Hub seal? How hard to replace?


Jun 22, 2010 | 2006 Chevrolet Silverado

1 Answer

Trans leak on a toyota pickup

No there is no internal oil seal in the tail housing.
Maybe you damaged the seal when refitting the tailshaft.. It is easy to do.. Did you grease the seal so the tailshaft wouldn't damage it upon reinsertion?

Jun 27, 2009 | 1985 Toyota Pickup

1 Answer

Leak from Drive shaft output seal

Does it leak from off the driveshaft?
If yes , thn check the diameter of the driveshaft where the seal lip touches.

May 22, 2009 | 1993 Dodge Caravan

1 Answer

Leaking Tcase after replacing seal?

If you did not damage it during install, you may have a bad output bearing which is allowing shaft to move up & down, check shaft to see if it moves. Generally unless there is a pronounced groove in the yoke seal surface it will not leak. (I generally put a small amount of rtv black on outside of seal to prevent any seepage around outside.

Apr 15, 2009 | 1989 Jeep Grand Wagoneer

2 Answers

Rear output shaft seal on transfer case is leaking hummer h2

How to remove axle shaft seal on hummer H2

Feb 20, 2009 | 2005 Hummer H2

Not finding what you are looking for?
1999 Ford Crown Victoria Logo

Related Topics:

90 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

71525 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22059 Answers

Ron Lankford

Level 3 Expert

5386 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides