Question about 2007 Hyundai Santa Fe Limited

1 Answer

2008 Santa Fe SE. Doors lock when ignition is turned on - OK.

But they unlock when the ignition is turned off. I would like them to lock at about 10mph, and unlock manually. Don't feel safe having the car open whenever I turn the engine off. Can this be adjusted?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 840 Answers

No there is not its the way the automakers had planned it / most vehicles have that feature/Please rate my response Thank you very much

Posted on Jan 31, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

4x4 diesel. Why can't doors be unlocked or locked?


their is a way to do it but recheck battery first sometimes the relearn process doesnt work or the fob itself is dead also if auto /remote start will need dealer to flash fob ---- 2002 santa fe and followed programming instructions and eventually was able to program the new remote. But, I did not realize I had to program my existing remote at the same time. Since, I have retried programming both remotes many times with no success--the new one works, but the old one won't. The instructions were: 1) Locate switch under dash, behind fuse box; 2) Turn ignition switch on, but don't start engine; 3) Wait 5 seconds, set memory switch to SET position; 4) Press remote LOCK button; press second remote transmitter LOCK button; 5) Set memory switch to OFF; 6) Switch ignition OFF. 7) Confirm programming by locking and unlocking vehicle.
Remote Key Programming Hyundai Forums Hyundai Forum

Sep 23, 2015 | 2003 Hyundai Santa Fe

1 Answer

Is there a way to remove the BEEP sound when locking or unlocking the doors on a 2014 Santa Fe Sport 2.0 T Limited?


Try pressing both the open and lock buttons on your remote simultaneously. Works on some asian cars.

Sep 28, 2014 | 2014 Hyundai Santa Fe Sport

1 Answer

Ingition lock on 2003 santa fe


you will need to reprogram the key

Nov 28, 2013 | 2006 Hyundai Sonata

2 Answers

My drivers side rear door will not open from the inside or outside


I had exact problem Santa Fe 2007 2008 lock was stuck in locked position and door would not open from inside or out. All other doors would unlock with auto key remote. Carefully work the inside lock towards the open position as you lock and unlock the door with the remote. As you press unlock try to assist the lock to open. I did this a few times and the lock became free to the open position and all worked perfectly after this.

Feb 02, 2013 | 2007 Hyundai Santa Fe Limited

1 Answer

Buy 2002 Santa Fe Nov 16, couldn't unlock doors to


i had a problem not unlike this in my santa fe 1.9td uk spec.
my car had been sitting for a few months and when i returned to drive it again the same problem came to light.
i also rep[lsaced the key fob.
it could be one of two things.
firstly the systen might neen re-set. if you disconnect the battery for 2 hours then attach ti again it might work.
if this fails it might be the actuator in one of the doors. if it is faulty then it only semi closes the lock, but it then thinks that has to lock again. and locks the door.
hope this helps.
oscargilpin

Dec 10, 2009 | 2002 Hyundai Santa Fe

1 Answer

Hyundai santa fe 2002 remote key fob locking ok but fails to unlock. suspect micro switch faulty. can it be replaced?


Do the doors lock normally when using the manual switch on the dirver's door panel? If so, the problem is in the ETACS module. Here's the wiring diagram:

5f27f1c.jpg

May 16, 2009 | 2004 Hyundai Santa Fe

1 Answer

Central locking wont stay open


Here's what I suspect is happening. The door locks will lock and unlock normally when the key is OUT of the ignition. If the key is IN the ignition, the doors cannot be locked (manually, key fob, or otherwise, if the system is operating as designed - prevents the doors being locked when the key is in the ignition). I've seen this problem before, but on a Santa Fe, not an Accent. The ground signal of the right hand front passenger door was lost, and the doors automatically locked. Perhaps something similar is happening in the circuit between the ETACS module and the right front passenger door lock/unlock actuator. Could be anywhere in the circuit.



d05b136.gif
ab4c712.gif These wiring diagrams may be helpful. The relays expecially may help solve this issue. As you can see, these relays are also controled by the ETACS module (Remote Keyless Entry).

67dc553.gif

Mar 31, 2009 | 2003 Hyundai Accent

2 Answers

2004 Santa Fe Ignition switch locked


I just had this happen to me yesterday with my 2002 Santa Fe. After trying everything (jiggling steeling wheel, shaking the car, you name it we tried it). We got a chain and pulled the car ahead about 2 feet. That didn't seem to do anything but we then pulled up the emergency brake into the lock position and tried to start the car (with the ER brake on) and it worked!!! The steering wheel came unlocked and the car started up. Don't know if it was the pulling of the car that broke something free or if it was the ER brake, but that was what worked for me.

Jan 11, 2009 | 2004 Hyundai Santa Fe

Not finding what you are looking for?
2007 Hyundai Santa Fe Limited Logo

Related Topics:

129 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...