Question about 2005 Jeep Grand Cherokee

1 Answer

Power windows, locks, and seat not working

Power windows, power door locks, and power seat not working from any doors/switches. All fuses including IOD good and door wires all in tact. Also there is a clicking noise coming from behind the interior fuse box when the door lock is pushed.

Posted by on

  • Matt7311 Jan 31, 2009

    Fuse F8 in Power Distribution Center ended up being the fix,http://www.wkjeeps.com/wk_fuses.htm. FYI: this is fuse for power windows, locks, and seat in 2005 - 2007 Grand Cherokee.

  • Matt7311 Feb 03, 2009

    Fuse blew after about an hour of driving time. Any ideas on source of problem?

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,990 Answers

That Clicking should be a Bad Relay Switch. See if you can Locate it and Replace it. It should fix this Problem for ya! Please Rate My Response! Thanks!

Posted on Jan 31, 2009

  • Travis Humphries
    Travis Humphries Jan 31, 2009

    Awesome! Glad I could Help!

  • Travis Humphries
    Travis Humphries Feb 03, 2009

    If the Relay is Bad it will trip the Fuse. Check the Relay's in the Box under the Hood. I would replace it whether it seams to be good or not since it is still tripping fuses.

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What could cause my power windows not to work?


Usually it is in the drivers window controller.There is a module that usually goes bad.

Dec 14, 2014 | Cars & Trucks

1 Answer

2007 Chevy Trailblazer no power @ drivers door


Check the fuse from the manual and replace else, the ground wire on the right door panel has got open / cut.

May 22, 2014 | 2007 Chevrolet Trailblazer

1 Answer

Power lock and power windows dont work can`t find fuse


Number 21 is for the door lock fuse and relay, its a 10 amp fuse.
Number 7 is for the body control module, its a 10 amp fuse.

The fuse panel is under back seat.If all fuses checked out ok,then its faulty drivers door module called as DDM.

----------

For all types of power window problem and power windows not working,i suggest you to go through the help links given below.Click the link to go through its procedure to troubleshoot the problem :------

driver side power window problem?
http://technoanswers.blogspot.com/2011/06/driver-side-window-problem-on-mercury.html

-----------

Driver side power window wont go up?
http://howtobyme.blogspot.com/2011/10/driver-side-power-window-wont-go-up-on.html


---------

Power window problem
http://repairhelpcenter.blogspot.com/2012/01/pontiac-grand-am-power-window-not.html
------------

rear door or window will not open ?
http://technoanswers.blogspot.com/2011/06/rear-door-or-window-will-not-open-on.html
--------------
How to remove door panel, door window motor and regulator ?
http://technoanswers.blogspot.com/2011/05/how-to-remove-door-panel-door-window.html

--------

Power windows not working after car wash?

http://howtobyme.blogspot.com/2011/11/power-windows-not-working-after-car.html
---------power locks, power window and power mirror not working?
http://howtobyme.blogspot.com/2011/09/power-locks-power-window-and-power.html

All power windows not working?
http://howtobyme.blogspot.com/2011/09/all-power-windows-not-working-on-2003.html
------------
How to remove window motor and regulator on Volkswagen Car?
http://howtobyme.blogspot.com/2011/09/how-to-remove-window-motor-and.html

-------------Complete Diagnosis & Testing Power Windows?

http://repairhelpcenter.blogspot.in/2012/02/diagnosis-testing-power-windows.html

------------

How to replace power window motor in car?
http://schematicsdiagram.blogspot.com/2011/06/how-to-replace-power-window-motor-in.html
----------
HOW TO REPLACE A POWER WINDOW SWITCH
http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-power-window-switch.html
------------
How to Replace a Window Motor
http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-window-motor.html
----------
HOW TO REPLACE A WINDOW REGULATOR WITH MOTOR
http://schematicsdiagram.blogspot.com/2011/08/how-to-replace-window-regulator-with.html
---------
HOW TO REPLACE WINDOW RUN CHANNEL SEALS
http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-window-run-channel-seals.html
-------
HOW TO REPLACE A WINDOW REGULATOR
http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-window-regulator.html


-----------This will help.Thanks.

Jan 22, 2012 | 2006 Chevrolet Trailblazer

2 Answers

I have a 1998 chevy suburban. The dome lights don't work. checked fuse box under hood. All good. Are there other fuses on the truck?


Instrument Panel Fuse Block
The instrument panel fuse block access door is
located on the driver side edge of the instrument panel.

Pull off the cover to access the fuse block.

The vehicle may not use all of the fuses shown.

Fuses Usage
1 Rear Seats
2 Rear Accessory Power Outlet
3 Steering Wheel Controls Back light
4 Driver Door Module
5 Dome Lamps, Driver Side Turn Signal
6 Driver Side Turn Signal, Stop lamp
7 Instrument Panel Back Lighting
8 Passenger Side Turn Signal, Stop lamp
9 Passenger Door Module, Driver Unlock
10 Power Door Lock 2 (Unlock Feature)
11 Power Door Lock 2 (Lock Feature)
12 Stop lamps, Centre High Mounted Stop lamp
13 Rear Climate Controls
14 Power Mirror
15 Body Control Module (BCM)
16 Accessory Power Outlets
17 Interior Lamps
18 Power Door Lock 1 (Unlock Feature)
19 Rear Seat Entertainment
20 Ultrasonic Rear Parking Assist, Power Liftgate
21 Power Door Lock 1 (Lock Feature)
22 Driver Information Centre (DIC)
23 Rear Wiper
24 Cooled Seats
25 Driver Seat Module, Remote Key less Entry System
26 Driver Power Door Lock (Unlock Feature)

Aug 23, 2011 | Chevrolet Suburban 2500 Cars & Trucks

1 Answer

Front driver door has no power, I have checked the fuses but no controls will work


This is a manufactures bulletin


SUBJECT:
Inoperative Right Front Door Switches OVERVIEW:
This bulletin involves replacing the right door interior handle. The loss of ALL functions may occur when attempting to control them from any of the switches located on the right door due to electrostatic discharge through the right door interior handle. The right door interior handle must be replaced to protect the switch module from static electricity. The new handle is more resistant to electrostatic discharge. MODELS:
2004 - 2008 (CS) Pacifica SYMPTOM/CONDITION:
The vehicle operator may experience a permanent loss in ability to actuate ALL of the following functions from the right door switches: ^ Power door locks. ^ Right power mirror. ^ Right power seat adjustments. ^ Right power window control. ^ Right heated mirrors. ^ Memory functions associated with the listed systems on right side (if applicable). ^ Loss of communication with the right door switch module to Scan Tool: DIAGNOSIS:
Perform a "Hard Reset of the right door switch module. This may be accomplished by removing all power (including memory keep alive power) from the right door switch module by unplugging the module power connector. Alternatively, vehicle power may be interrupted by removing the negative battery terminal when the ignition switch is in the OFF position. If after performing the hard reset functions of the right door switches return perform the Repair Procedure.
dak408_79.gif

PARTS REQUIRED:
REPAIR PROCEDURE:
1. Disconnect the negative battery cable. 2. Remove the right door trim paneldak408_80.gif
3. Remove the door tweeter speaker. Refer to the service information in TechCONNECT. Refer to 8 - Electrical > Audio > Speaker > Removal (Fig 1). 4. Remove the power seat switch. Refer to the service information in TechCONNECT. Refer to 8 - Electrical > Power Seats > right Seat Switch > Removal. 5. Replace the right door interior handle, p/n 05170261AA, as described on Mopar Instruction Sheet K6855628 included in the handle kit. 6. Install the power seat switch. 7. Install the door tweeter speaker. 8. Install the right door trim panel. 9. Connect the negative battery cable.

Nov 25, 2010 | 2006 Chrysler Pacifica

1 Answer

Sunroof will not work


Power is supplied to the Power windows and sunroof through the power window circuit breaker. That circuit breaker is supplied power through the RAP (retained accessory power) Relay, the RAP relay also supplies power to the radio. The RAP relay is also fuse protected by the RAP fuse in the under hood fuse block. The RAP relay is energized by the BCM body control module.

The RAP relay is responsible for the radio and windows working after the igntion is turned off.

The first place to check would be the RAP fuse in the under hood fuse block and then the RAP relay in the Body fuse block.

A list of the BODY relay block located on the left side of the dash to the right of the interior fuse block is below:

(1) Park Lamp Relay (2) Courtesy Lamp Relay (3) Retained Accessory Power (RAP) Relay (4) Power Seats Circuit Breaker (5) Power Windows Circuit Breaker (6) Inadvertent Power Relay (7) Door Lock Relay (8) Headlamp Ground Relay (9) Driver Door Unlock Relay (10) Door Unlock Relay(1) Park Lamp Relay
(2) Courtesy Lamp Relay
(3) Retained Accessory Power (RAP) Relay
(4) Power Seats Circuit Breaker
(5) Power Windows Circuit Breaker
(6) Inadvertent Power Relay
(7) Door Lock Relay
(8) Headlamp Ground Relay
(9) Driver Door Unlock Relay
(10) Door Unlock Relay
(1) Park Lamp Relay (2) Courtesy Lamp Relay (3) Retained Accessory Power (RAP) Relay (4) Power Seats Circuit Breaker (5) Power Windows Circuit Breaker (6) Inadvertent Power Relay (7) Door Lock Relay (8) Headlamp Ground Relay (9) Driver Door Unlock Relay (10) Door Unlock Relay (1) Park Lamp Relay (2) Courtesy Lamp Relay (3) Retained Accessory Power (RAP) Relay (4) Power Seats Circuit Breaker (5) Power Windows Circuit Breaker (6) Inadvertent Power Relay (7) Door Lock Relay (8) Headlamp Ground Relay (9) Driver Door Unlock Relay (10) Door Unlock Relay

Jul 10, 2010 | 2000 Chevrolet Blazer

1 Answer

1993 Ford F150 4X4 Power door locks, power window on passenger side and lumbar control on seats stopped working


CK FOR POWER TO LOCK @ WINDOW SWITCH IT COMES FOR MASTER WINDOW SWITCH ON LEFT SIDE DOOR NOT SHORE ON LUMBAR CONN.UNDER SEAT CK IT FOR POWER

Aug 11, 2009 | Ford F-150 Cars & Trucks

4 Answers

2004 Jeep Grand Cherokee driver side power windows do not work


I had the same problem with now power to windows, mirrors and seat. The common soulution is the orange and or black wire in the boot have broken between the door and post.

Nov 25, 2008 | 2004 Jeep Grand Cherokee

2 Answers

Power Door Lock Problem


The last post by maddog1321 was exactly what I had with my right rear door. The electric locks would not lock and unlock, and you almost couldn't do it manually without my feeling I was about to break something. I took the door panel off, oiled everything and got no relief. Finally, I saw the above post and drilled out the aft-most pop-rivet. THE WINDOW WORKED PERFECTLY! I didn't drill out the forward (closest to the handle) pop-rivet because I wanted to do one at a time so the solenoid would not fall out of place. I then put a new pop-rivet in place of the one I drilled out. I then reinstalled everything and the locks work like new.

Jul 31, 2008 | 1999 GMC Suburban

Not finding what you are looking for?
2005 Jeep Grand Cherokee Logo

418 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...