An expert who has achieved level 3 by getting 1000 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert whose answer got voted for 100 times.
Re: replace broken fuel door 2000 dodge caravan
If you're on the smallish side and pretty limber, you might avoid removing the rear wheel. If not, you will likely need to remove the rear wheel and put the van on jack stands securely. I would remove the underside splash shield and gain access from underneath. It looks like you will need to unscrew the plastic insert that surrounds the filler neck inside the area that is exposed when you open the fuel door. Make sure you get the vent hooked up correctly when you are done.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Most likely the problem is a broken blend door inside the heater box or a broken adjuster cable going to the blend door, the blend door inside the heater box is responsible for heater output depending on your temp adjustment on your heater control panel, most likely the blend door is stuck in the cold position allowing cold air to come through the vents verses allowing the blower motor to blow warm air past the hot heater core to produce heat, check the temperature adjuster cable behind your heater controls and make sure its connected and not broken, lastly make sure the blend door isnt broken and operating freely.
yes it will swap and you have to remove it from the bottom of the van remove the screw/clips from inside the filler door and then from underneth disconect the filler tube ti tank and the vent hose to the tank i belive there is a bracket also holding the filler tube to the body with one bolt then it snakes out of the va r insalating is just reverse
Sounds like a "mode" door issue. Either the door is broken or the motor that operates it is faulty. There are very few wiring issues with these motors, so I'd guess the door motor. Unfortunatly, the door is located inside the heaterbox and is not accessable without dash and heaterbox removal. This is a job for a qualified technician as the a/c system must be drained first. If the problem is a motor, then some are accessable by removing the panels aound the heaterbox. Listen for the door movements while operating in a quiet setting. You should be able to hear the door move if the motor is operating. Listen close, it's quiet.
Hope this helps, let me know if I can do more.