Question about 2008 Chevrolet Equinox

1 Answer

How do I adjust the head lamps on 2007 equinox

One is pointing down further than the other

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 840 Answers

Look at the tops of the headlights there are 2 torx screw in the top one opn each side of the light tom move them just simply get a torx and rotate the screw thats it/ Please rate my response thank you very much

Posted on Jan 31, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 chevy equinox, running lights are not working, fusses work fine, what else would be the problem?


The problem is your not familiar with electronic's on modern automobiles . Module controlled systems . BCM - body control modules .
The park lamps consist of the park, tail, marker and license lamps. These lamps are illuminated any time the headlamp switch is in the PARK, ON position, or anytime the body control module (BCM) illuminates the headlamps. The PARK fuse in the fuse block - instrument panel (I/P) supplies voltage to both the coil and switch input side of the park lamp relay. The BCM controls the park lamp relay by grounding the park lamp control circuit energizing the relay.

PCB Relays
This vehicle is equipped with the following PCB mounted relays. High Beam, Low Beam, DRL, Fog Lamp, Park Lamp, Stop Lamp, and Horn relay. They are directly soldered to the underhood fuseblock circuit board. A failure of one of these relays will require the whole underhood fuseblock to be replaced.

Your best bet have a qualified repair shop diagnose the problem . Could have DTC'S - diagnostic trouble codes stored in the BCM For circuit faults .
Park Lamp Switch On
B257A 00
B2057A 00
B257A 00
--
When the headlamp switch is in the OFF position, the body control module (BCM) receives a ground signal through the headlamp switch OFF circuit and an open signal on the park lamp ON circuit. When the headlamp switch is in the PARK or HEAD position, the BCM receives an open signal through the headlamp switch OFF circuit and a ground signal through the park lamp ON circuit.

DTC B2585 00: Park Lamp Control Circuit - Domestic

Jan 17, 2017 | 2007 Chevrolet Equinox

1 Answer

2007 chevy equinox license plate light won't work after bulb and fuse replacement


Do the park lamps work ? license plate lights get power from same fuse ! Check ground wire ! use a volt meter an do voltage drop test ! Voltage Drop Testing The fuse for the license plate lights is in the under hood fuse box -engine compartment ! fuse #12 RT PRK LAMP 10Amp .

May 23, 2015 | 2007 Chevrolet Chevrolet Equinox LT

2 Answers

Was there a recall on gas tank for chevy equinox


well gm had a lot of issues with them but they dont want to do anything about it am working on a 2010 now with some problems,what is your problem sir,if the fuel is spilling out let me knw plz

Jun 25, 2014 | 2007 Chevrolet Equinox LS New Cars

1 Answer

High beam in 2007 Impala pointing down after changing bulb.


Check for proper installation if you you install it properly you should have adjust the head light again by two nut behind the head light one for vertical another for horizontal

Dec 04, 2013 | 2007 Chevrolet Impala

1 Answer

Is there a recall on the 2007 chevrolet equinox


here is what is out there, you need to take or call a gm dealer to find out if any apply to your vehicle

12190 Product Safety Fuel Odor or Spotting on Ground - Inspect Fuel Pump Module
10117A Product Safety Voltage Regulator Internal Low Resistance Short
07182 Airbag System Passenger Sensing
10250 Special Coverage Adjustment Spark Plug Wire Warranty Extension
07281A FMVSS Noncompliance Head Impact Protection Add Additional Energy Absorbing Device
07174 Airbag System Passenger Sensing
07154B F/CMVSS Noncompliance Windshield Liftgate Glass Side Stationary Glass Retention Replace Glass
10037B Customer Satisfaction Program - Unwanted Repeat Calls to OnStar
07287A Customer Satisfaction Increased Head Impact Protection
07224A Customer Satisfaction Electronic Stability Control Disabled without Warning Reprogram Computer Module
07136 Customer Satisfaction Instrument Panel Trim Separation

Jan 15, 2013 | 2007 Chevrolet Equinox LS New Cars

1 Answer

Head light adjustment for a pt cruiser drivers side replace lamps low on drivers side when driving points down


there should be an adjustment screw or torx head bolt that will turn and raise the light

Mar 26, 2011 | Chrysler PT Cruiser Cars & Trucks

1 Answer

2006 sonata


HEAD LAMP AND FOG LAMP AIMING POINT
fdb7b15.gif

May 23, 2008 | 2006 Hyundai Sonata

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

190 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

67757 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22005 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6817 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...