Question about 1993 Acura Legend

1 Answer

No fuel plenty of spark

The engine has spark but the fuelpump electrical connector has no output 1993 acura legend 3.2

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 491 Answers

Check the relay and the pump itself

Posted on Jan 31, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1993 honda acura legend removing power left side


if your removing the seat there are 4 bolts that secure the seat rails to the floor of the car these are what the seat moves back and forth on, that need to be removed then find the electrical connector and unhook then remove the seat.

Aug 27, 2014 | 1993 Acura Legend

1 Answer

Will not start. The engine turns over, but will not start


most , guys will just assume the engine is ok, that is has good compression with fingers crossed and then
1:operators guide, use WOT cranking to unflood, it. oops don't start.
2: so, checks spark to all cylinders. no spark no run.... ever.
3: if spark is good, he tries test fuel.
fails, mech then he thinks, gee , is engine really good? hummmm
id does use the strobe light to sees spark is landing right.
No, it is not?, must be cam timing slip. belt or change (belts fail 10x chains but owners ignore the chain screaming, sooooo)

ok timing (both) is good, he pulls 1 spark plug , omg , these are 10 years old
he says,,, and black and soaking in gas, tuneuptime.
ok they all look good, and runs on test fuel now. then stalls in 3sec.
well, bad fueling (ask why, much longer story,,,,,,,,,,!!!!)

http://www.youtube.com/watch?v=064Ilsz8Fzg&NR=1&feature=fvwp

Jan 21, 2014 | 1993 Acura Legend

1 Answer

Will alternator off a 92 accord fit on a 92 acura legend


what a hard question... so many things to check
.internal reg, or PCM reg.
Amp output and physical fit. pulley size, type, and clocking. connector type, and pinout., to say the least.

i picked an autostore, at random , and it dont match.
not only that, you risk blowing your engine PCM using the wrong alt.
you never said which car was the donor, so can really answer fully.
my guess the legend.

the legend has an internal reg.
the accord is PCM controlled, a hopeless match
i looked this up, on alldata.com , schematics.


Jan 16, 2014 | 1992 Acura Legend

2 Answers

Can the engine of the 1993 Legend fit the 1990 Legend and vise versa?


Sure, just might be a few cosmetic differences - as long as they're same engine size.

Feb 18, 2011 | 1991 Acura Legend

1 Answer

1993 acura lengend i change the timing belt reset the timing and now the car wont start, it is getting compression and fuel but no spark the coil, fuses are good all wires are conected but still no spark....


There are six coils on the Acura and they are governed by the ECU. The crank position sensor feeds the signal to the computer and is located under the Camshaft pulley on the left (or front) bank of cylinders. You have disconnected it to get the pulley off and may have jammed the small male probes of the connector while putting it back on. You can re-align them and try again. The sensor also may have been damaged and is not "reading" and giving the ECU information to sequence the injectors. It should show on your engine fault code (OBD2 scan). Take out the ALT/Sense fuse to re-boot the computer codes and check. The 93 coupe has variable valve timing and lift control (VTEC) and the ECU controls intake and fuel pressure.

Oct 20, 2010 | 1993 Acura Legend

1 Answer

Where is fuel pump relay on acura legend 89 i dont know if i need a fuel pump or fuel filter


where is the fuel pump located on my 1994 acura legend and how to check the relay and where is it located

Oct 01, 2010 | 1993 Acura Legend

1 Answer

How do u reset a fuelpump for a 92 acura legend some one told me theres a botton or could it be the relays my fuel pump dont start and one of my relays get realy hot


sounds like your pgmfi main relay has gone bad,pretty common on this car.it is located above the drivers knee bolster panel. 1"x1"x3" retangular box single plug

Dec 27, 2009 | 1992 Acura Legend

4 Answers

1990 Acura Legend, location of main relay for fuel pump


looked it up online, looks like its in the underhood fuse box but couldn't get a good diagram that shows which relay number it is. the website i use is sort of dependent on the manufacturer, apparently acura did not feel like sharing that info. hope that helps

Jun 17, 2009 | 1993 Acura Legend

Not finding what you are looking for?
1993 Acura Legend Logo

Related Topics:

120 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

yadayada
yadayada

Level 3 Expert

64286 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...