Question about 2005 Nissan Murano

1 Answer

Replacing a cracked side-view mirror

My side-view mirror on the driver's side has a crack and i ordered the replacement mirror and i need to put it on myself

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 840 Answers

Well the best way is to take the inside mirro cap off there are 3 bolts that need to be taken out 10mm if its not accessible from there you need to loosenthe trim panel and take it off look around for hidden pop ups take the pop ups out and take the screws out then from there pull the bottom of the door trim out and slide arms around the edges and pull out there then pull up and outThanks for using fix ya. Please rate my response thank you very much

Posted on Jan 31, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to fix electric wing mirror Honda crv


How To Install Replace Side View Mirror Honda CR-V 02-06 ...

? 10:31
https://www.youtube.com/watch?v=tuGFzxCVh7k
May 8, 2012 - Uploaded by 1A Auto Parts
In this video, 1A Auto shows you how to repair, install, fix, change or replace a broken, smashed, cracked, or ...

Replace 2002-2006 Honda CR-V Side Mirror, How to ...

? 14:20
https://www.youtube.com/watch?v=UKLPkZszbrA
Sep 25, 2013 - Uploaded by Go-Parts
Side Mirror purchased from www.Go-Parts.com Links to purchase products: ...

2000 Honda CR-V side mirror replacement - YouTube





Dec 16, 2015 | Honda HRV Cars & Trucks

1 Answer

I have a 2006 Kia Sorento. The driver side view mirror got cracked in a minor accident. Only the mirror got cracked, but the entire casing is still in-tack. Do I need to replace the whole casing or can I...


Yes you can replace it yourself, but you must be extra careful, the mirror glass is attached to a holder that can be removed ( not sure how in Sorento) and that the replacement mirror can be attached. Try to have a look at the new replacement and you will be able to figure out how.

Dec 13, 2010 | 2006 Kia Sorento

1 Answer

I have a 2006 Kia Sorento. The driver side view mirror got cracked in a minor accident. Only the mirror got cracked, but the entire casing is still in-tack. Do I need to replace the whole casing or can I...


Any shop that replaces windshields can replace just the glass in your mirror usually for around $25-$35. It's not a hard job and it takes about 20 minutes. They might even do a little better on the price if you don't need a receipt. You can do it yourself if you can get the mirror. You need some silicone adhesive, electrical tape and a couple of wood or plastic blocks.Clean all the broken mirror out and clean the glue off in the case. Run a bead of silicone around the inside of the new glass about 1-2 inches from the edge and put a couple of dabs in the center part. If your silicone is too close to the edge, when you press the new mirror on the glue will squeeze out and glue the mirror to the case. Press the new mirror into the case and wrap the electrical tape around the case and over a block on the face of the mirror. You want the tape pulled a little tight so it puts pressure on the glass but not tight enough to break it. Do this on each end of the mirror and leave it for 24 hours, then remove the tape and blocks. Hope this helps.

Dec 13, 2010 | Kia Sorento Cars & Trucks

1 Answer

I've got a broken driver side rear view mirror on a 1990 Buick Century. I've got the replacement mirror, I just need help getting the old mirror off the door. Suggestions?


This is what you do take the door skin off of the inside of the door and at the top corner there will be i think three nuts and than your going to need door clips after your done in order to put the door panal back on

Apr 07, 2010 | 1990 Buick Century

1 Answer

How do I replace driver side view mirror


There is a triangular piece of plastic inside the door opposite the mirror. You remove the panel and you'll see 2 bolts. Remove the bolts and unplug the wire connector (if you have electric rear view mirrors) and the mirror will come right off. Installation is reverse.

Apr 07, 2010 | 2006 Chrysler PT Cruiser

1 Answer

Need to replace driver side mirror. The mirror is


gm does make just a mirror glass than you can get at you local dealer.First ck all the clips on the mirror and make shure that they are not cracked

Feb 24, 2010 | 1994 Pontiac Grand Am

1 Answer

How to replace just the glass on my side mirror


Go to any glass shop, they'll cut a new mirror and glue it on top of the old one. Much cheaper than replacing the whole unit (hundreds).

Jun 10, 2009 | 2004 Ford Expedition

2 Answers

Replacing a rear view mirror


You have to CAREFULLY ( probably wise to wear safety goggles ) and with a flat blade screwdriver, pry out ALL the broken mirror glass wearing gloves. Now with the 2 adhesive strips, align mirror glass and adhere to base. Hope this helps

May 13, 2009 | 2008 Subaru Forester

1 Answer

Replacing 1994 Cavalier Driver's Side Mirror


I would use a strong adhesive and apply new mirror glass on top of the cracked glass. When done properly will create a permanent repair

Mar 25, 2009 | 1994 Chevrolet Cavalier

1 Answer

Need to replace passenger side view mirror 200 GMC Jimmy Diamond


On my '97, there was a triangular shaped piece of plastic on the inside trim that had to be removed. I think all three mounting screws were under that. It's been a few years, but I think that was how it was done.
I remember it was pretty easy though.

Jan 29, 2009 | 2000 GMC Jimmy

Not finding what you are looking for?
2005 Nissan Murano Logo

543 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...