Question about 2004 Oldsmobile Silhouette

1 Answer

I have a 2004 silhoutte and the power door lock on the right side will not unlock or lock the door to open

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,201 Answers

If it won't unlock with either switch,(drivers door, or passenger door switch) take the door panel off and check the actuator valve that operates the lock.

Posted on Jan 31, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 Jeep Cherokee sport. Power door lock won't


Lock and unlock both run off the same power supply...I'd be looking for a bad switch or a broken wire in the door harness where the wires go through the rubber boot between the door and pillar.

Feb 08, 2010 | 2004 Jeep Grand Cherokee

3 Answers

Driver side door doesn't lock or unlock with the remote. The rest of the doors work fine.


Does the Driver side door lock and unlock from the lock switch inside? If not then you have a bad motor or bad connection to the lock/unlock motor inside the door.

Jan 08, 2010 | 2004 Toyota Camry

1 Answer

2004 Chevy Venture Passenger side sliding door stopped opening with button, can still open and close manually, at same time backup lights do not work and power door locks do not automatically lock and...


It sounds like you've got a broken wire on the drivers side door. Usually this occurs at the flex point of the wiring harness. Peel back the outer covering carefully exposing the wires inside. Repair any broken or those about to break. Solder & retape or shrink rap with heat gun.Hope this helps. Good luck!

Nov 24, 2009 | 2004 Chevrolet Venture Passanger

1 Answer

2004 Dodge Ram 1500 Quad Cab Drivers side power door lock broken


Sounds like the link rod to the latch are jammed in the locked position by something inside the door or it came off. Any way, you have to remove the door panel to get access to it.

May 27, 2009 | 2004 Dodge Ram 1500

1 Answer

Driver side door will not unlock with key or with keyless entry


frist check your wires and make shore you have power. if your lock still dont work its the power lock motor in that door ok . have a nice day

Mar 29, 2009 | 2004 Kia Optima

1 Answer

2004 toyota sienna sliding door locking trouble


Sounds like something isn't right.Try to disconnect the battery for a few minutes and see if that helps.Some times the ecu gets haywired and disconnecting the battery might reset it.And if it is the original battery you might want to get it tested.

Dec 03, 2008 | 2004 Toyota Sienna

4 Answers

Fuel tank


IF you pop your truck remove the plastic insert that hold in the trunks carpet on the right side you see a little box that has a push pull button on it. This controls your release for your fuel tank door.
PLay with it you will figure it out....

Oct 14, 2008 | 2004 Infiniti G35 Sport Coupe

1 Answer

Door locks


Regarding the rear door child locks: There is a small lever on the latch side of the door, you can only see it with the door open. Move it to the other position.

Regarding the front door locks: You either have a bad door lock switch, or the power lock solenoids are beginning to fail. To check this, you will need to pull the door panels off, & measure the actual voltage at the solenoids whilst manipulating the lock switch. If you have 12 + VDC, I would suggest replacing the door lock solenoids. Not hard to change, but it IS time consuming. Best left to a dealer. Expect to pay 1 hour per side to change each solenoid.

Sep 28, 2008 | 2004 Toyota ECHO

Not finding what you are looking for?
2004 Oldsmobile Silhouette Logo

Related Topics:

242 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

64052 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...