Question about 1994 Ford Aspire

1 Answer

The car will not go into gear, and it stalls at idle

I have a 1994 Ford Aspire that sat for 2 years. It starts however it will not go into gear sometimes. Once you finally get the vehicle in gear it stalls. I have changed the oil and collant. The air filter has also been changed. Actually changing these items seems to have added to the problem.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 2,920 Answers

It sounds like the timing might be out on it

Posted on Jan 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Stalling issue


an 03 has a gen 2 OBD that stores faults (not all faults trip the ck engine light) i would start there by doing a download (all faults)with a code ck'er , could be something as simple as an idle adjustemnt or maybe a vac line got broken/left off when doing the plugs/wire change , happens!!!

May 13, 2014 | 2003 Ford F250 Super Duty Crew Cab

1 Answer

When start high idle put foot on break to put in gear then stalls


Doubt it's the O2 sensor.More likely an issue with your IAC(Idle Air Control) motor.Quite often they get plugged up with carbon and stick in position.

Jul 28, 2013 | 1994 Saturn Sl

1 Answer

1994 ford ranger idle fine under load it stalls and brakes are not working.


Are you saying the booster is not working, and if so that would mean there is a vac leak somewhere ?

Sep 20, 2012 | 1994 Ford Ranger Supercab

1 Answer

1990 lincoln town car 5.0, hard to start then


air idle control motor probably sticking remove motor and spray w-d-40 inside then reinstall and tap with a hammer while running

Dec 07, 2009 | 1990 Lincoln Town Car

1 Answer

1994 ford escort vibrates horribly in idle, does not stall. Idle is set @ 800rpm, runs smooth when raised to about 1200rpm. Suggestions?


Your Idle air control valve is probably going bad. It is located on the throttle body and is a relatively easy fix as it is only held in with 2 screws. Good luck and thanks for using FixYa!

Jun 27, 2009 | 1994 Ford Escort

2 Answers

My daughter ford bronco 2 keeps stalling.


Automatic or Manual transmission?

Jun 12, 2009 | 1986 Ford Bronco

2 Answers

Vibration when in gear, and stalling.


The problem is the torque converter solenoid. I had it happen on my 94 Cavalier a few years back and was a cheap fix at the local car mechanic. What happens is the transmission warms up and hits a certain speed where the solenoid engages, but then it sticks and won't disengage until it cools down sufficiently. When it sticks, it causes the car to shake when slowing down and will snub out the engine if you come to a stop.

Mar 09, 2009 | 1994 Chevrolet Cavalier

2 Answers

1994 Chev Astro 4.3L AWD "W" OBD Code 43 168K Miles


code 43, i would expect with running rough but that's not the cause , its a result ,if the system detects noise (knock) it will try to compensate by retarding the timing to save the motor , built in self preservation , i hope your not running on 2 year old gas , i'd be amazed its even running at all , gas varnishes up bad enough in 6 months to 1 year , i suggest getting some fuel additive in there to stabilize and clean the fuel system , or have it drained and start over with fresh gas and go from there . cheers .

Jan 10, 2009 | 1994 Chevrolet Astro

1 Answer

Car stalls


TRY THIS PROCEDURE I DEVELOPED.

Here is the most common cause of surges and stalls and low idle, it is the idle speed control air-bypass valve and throttle valve (IAC for short), they get full of gunk over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

Nov 09, 2008 | 1994 Ford Thunderbird

Not finding what you are looking for?
1994 Ford Aspire Logo

Related Topics:

93 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...