Question about Cars & Trucks

1 Answer

ZAFIRA 2006 CANT REFIT SELECTOR SHAFT AFTER REMOVEL?

Posted by on

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 52 Answers

If you mean the gear selector. Fit it Into position. Remove the Cover from the gear lever, Hold the gear leaver to the left. Place a 6mm Allen Key or Small bladed screw driver in the hole on the left to lock the lever into position. Under the bonnet twist the 'Remote to the right or left(not sure which way). There is a White Pin with a spring on it. This will push in and lock. The gears should the n be set up. Tighten the lock nut on the selector 'Stub' that's on the rear of the gear box and bingo the gear leaver is set.

Posted on May 13, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Reverse gear problems


This is a selector problem. Check the selection starting from the gear lever going down. It might be inside the box itself if a dowel to the 5/r selector shaft has fallen off.

May 09, 2014 | Cars & Trucks

1 Answer

Vauxhall fault codes


in my car Vauxhall zafira this cod comes up which is u2100c and can u please tell me how to fix the problem , I change the car key battery . still the light is there.

Nov 29, 2013 | 2006 Opel Zafira 1.9

1 Answer

Poor heat in opel zafira 2006


You can try flushing the heater core by disconnecting both water hoses goin in from the engine bay. Stick a water hose on any of them to see how it comes out on the other side. Ive had this problem before and 99% of times is a clogged heater core. Also check heater control valve, sometimes the get stucked and not let water go into the core. I hope this helps!

Mar 26, 2013 | 2006 Opel Zafira 1.6

1 Answer

I have a question, Where can I find the place of color code in Opel Zafira 1.8 model 2006


engine bay there is a metal plate it will have numbers on it and paint code. near to were the locking pin is on the locator for the bonnet..

Mar 21, 2013 | 2006 Opel Zafira 1.8

1 Answer

Zafira juddering


vauxall zafira 1.8 04 plate auto . problem when on starting it doesnt let me rev and jerks on take off but after 2 minutes it runs fine worried incase start of bigger problem any ideas would be great.

Sep 15, 2012 | 2006 Opel Zafira 1.8

1 Answer

Trying to replace right front bearing hub and cv axle [bad boot on upper end] cv shaft outer hub will not clear the shock or stabalizer bar for removel and replacement on 06 f150 4x4 pulled bottom bolt...


If you have the jack in the correct location have you attempted to turn the front wheels to slightly adjust the angle of the hub relative to the shock and stabilizer bar?

Jul 25, 2010 | 2006 Ford F-150

1 Answer

I have to change the gear selector cable on a 1.4 renault megane 06 as mine has snapped. how difficult is is to do and do i do it from under neath or thru the top? can someone give me a step by step guide...


I have the same problem on my 06 1.4 megane, it is the neutral cable that has snapped, one nearest the passenger side. I have been told you must remove all centre console (4 spline key bolts and lots of plastic) remove the 4 bolts securing gear shaft and selector, then fron underneath the car, remove front part of exhaust followed by heat shield, then remove gear selector cables and withdraw selector mechanism, then replace cable and refit. I will be attempting this next week and will post any problems on here.

Jul 10, 2010 | 2000 Renault 181

1 Answer

Fiat punto8valve 1999. fitted clutch. unable to select 5th and reverse, after adjusting cable . removed and refitted selector bracket with gerbox at the beginning?


when you where taking off the selectors did you remove one of them by taking off a 13nut? if so the selector under this nut dropped into the gearbox and its not lined up properly u need to remove the top of the gearbox and allign it.takes some messing around to get it right

Sep 18, 2009 | 2006 Fiat X1/9

1 Answer

Replace ac clutch for 96 previa


is it manul or automatic either way you have to do the following remove prop shaft then unbolt the gearbox from engine then unbolt the gearbox mount and lower via a jack and pull back and the clutch is there in front of you six more bolts and its in your hand refitting is the reverse of removel you will be able to doit on the ground and use good axel stands and jacks

May 11, 2009 | 1992 Toyota Previa

1 Answer

03 punto when turn key starter motor clicks after few times motor gets warm is it easy to remove will it just need cleaning and refitting


You may as well get a reconditioned starter as the best cheap option. The main thing though is to disconnect the battery before tackling the removel of the starter motor. As for the removel of the starter motor, if you approach the job in a logical manner then it should not present too many problems. Look at the position of the starter motor and the securing bolts (these bolts will be tight) and look at the access you have to work in and remove the starter. Wire brush the threads of the bolts before refitting.

Aug 11, 2008 | Fiat 124 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

424 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...