Question about 1999 Hyundai Accent

1 Answer

Heater not working

Although the heater does work it takes a long timr to warm up. infact i can get to work before it will demist the windscreen properly. any ideas what i can do to get more warmth?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 122 Answers

The thermostat may need to be replaced. If its stuck open, you wont get much heat. Another option is to change the thermostat to a higher degree 190 or something like that.....

Posted on Jan 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2015 carens, its either front windscreen demisting OR car heating, but I need both. How to fix?


If you set the temperature to a high temperature when demisting, it should still provide heated air, just not through the dash vents aimed at you. Is that not sufficient? Does your car has seat heaters?

Nov 03, 2016 | Cars & Trucks

1 Answer

Air conditioner light stays on on my 2009 rio


Turn setting for window demister off , air con comes on automatically on some vehicles when windscreen demister is on

Jan 04, 2015 | 2009 Kia Rio

1 Answer

2006 x type saloon demist function does not work floor and other outlets o.k


the demist function should be for the windscreen. the a/c should kick on and put out heat at the dash vents. the combination between the a/c and the heat allows the system to evaporate any moisture in the air allowing it to warm you and evaporate any moisture on the windscreen, and anywhere else they may have it duct to so that vision is not impaired. enjoy!

Nov 08, 2009 | 2006 Jaguar X-Type

1 Answer

Heater wont work


it sounds like your heatercore is cracked dose the windscreen fog up when on demist if so you need to replace the heatercore

Jun 10, 2009 | Hyundai Excel Cars & Trucks

1 Answer

2001 ford focus defroster blows out ac vents


may be just a cable adjustment.


SECTION 412-01: Air Distribution and Filtering 2001 Focus Workshop Manual DESCRIPTION AND OPERATION Air Distribution and Filtering The new heating and ventilation system ensures even air distribution.
The temperature control and air distribution flaps are controlled by two operating cables. All vehicles have a recirculated air function, with the flap controlled by a servo motor.
Air is supplied to the windscreen and side windows regardless of the air distribution setting.
The clean air filter is fitted as standard in most countries. This cleans the incoming fresh air of pollen and dirt particles. It must be renewed after every 40,000 km under normal operation conditions, or after 20,000 km under difficult conditions. If no clean air filter is installed, a plastic grille is fitted over the air intake. This can easily be replaced with a clean air filter.
Air distribution operating switch
Face level The main flow of air enters the passenger compartment at face level.
Face level/floor level The main flow of air enters the passenger compartment in equal parts at face level and floor level, and a small amount flows to the demister nozzles of the side windows.
Floor level The main flow of air enters the passenger compartment at floor level, and a smaller amount flows to the demister nozzles of the side windows.
Demist/floor level The main flow of air enters the passenger compartment in equal parts at the windscreen and at floor level, and a smaller amount flows to the demister nozzles of the side windows.
Demist The main flow of air enters the passenger compartment at the windscreen and a smaller amount flows to the demister nozzles of the side windows.
Air distribution operating switch Air distribution operating cables
NOTE: The Bowden cables for LHD and RHD vehicles are identical. However, they are fastened to the air flap operating mechanism with the respective reverse side of their connectors.
The air distribution switch operates with two Bowden cables. The cables operate the air distribution valves in the heater housing.
To remove and install the cables, the rotary switch must be turned as far as it will go to the left. The air flap mechanism engages easily in this position, making the installation of the cables easier.
--------------------------------
Air Distribution Cable Control Assembly Removal
s1y~us~en~file=ani_caut.gif~gen~ref.gif CAUTION: Disconnect the battery ground cable. For additional information, refer to Section 414-01 .
  1. Remove the radio/cassette unit and the CD player (if equipped). For additional information, refer to Section 415-01 .
  1. Remove the bezel with heater/air conditioning controls.
  1. Remove the bezel with heater/air conditioning controls (continued).
    • Pull off seven electrical connectors (six shown).
  1. NOTE: To remove the Bowden cables, turn the rotary switches as far as they will go to the left.
    Remove the bezel with heater/air conditioning controls (continued).
    • Unclip the Bowden cables.
  1. Remove the lower driver's side footwell trim.
  1. Unclip and remove the air distribution Bowden cables.
  1. Unclip and remove the temperature control Bowden cables.
    • Unclip and remove the temperature control Bowden cables.
Installation
  1. NOTE: Route the new Bowden cables without kinks and check for easy accessibility.
    NOTE: To install the Bowden cables, turn the rotary switches as far as they will go to the left. The mechanism engages easily in this position.
    NOTE: The Bowden cables are identical for RHD and LHD vehicles, although they are fastened to the air flap operating mechanism with the reverse side of their connectors.
    Install the components in reverse order.
  1. Check operation of the Bowden cables.

Mar 17, 2009 | 2003 Ford Focus

1 Answer

Front screen demister on Audi Avant A4 2004


ONE OF THE HEATER DISTRIBUTION FLAP MOTORS FAULTY.UNSCREW GLOVEBOX AND YOU WILL SEE THE ONE THANS NOT WORKING(TURN ON BLOWERS TO TEST)

Jan 28, 2009 | 2005 Audi A4

2 Answers

My windscreen demister does not work, I can hear the heaters working but nothing comes out them


EASY FIX HAD SAME PROBLEM WITH MY AUDI A4 2002 JUST LAST WEEK.....WILL BE ONE OF THE CONTROL MOTORS FOR AIR FLOW...UNSCREW THE 4 OR 5 SCREWS THAT HOLD THE GLOVEBOX IN PLACE TAKE CARE TO UNPLUG GLOVEBOX LIGHT WHEN LIFTING OUT...NOW YOU WILL SEE ALL THE CONTROL MOTORS RIGHT-HAND SIDE OF YOU...EACH ONE CHANGES THE AIR FLOW ...THE ONE FOR THE WINDSCREEN IS THE ONE NEAREST TO THE FRONT OF THE CAR..UNPLUG THE WIRING CONNECTOR UNDO THE 2 SCREWS NOTING HOW THE MOTOR SHAFT ENGAGES...EASY....IF YOUR UNSURE WHICH CONTROL MOTOR IT IS TURN ON YOUR BLOWERS AND TEST EACH ONE..SIDE VENTS, DEMISTER,ETC...TRY AND GET A SECONDHAND CONTROL MOTOR FROM SCRAP YARD...DEALERSHIP PRICES JUST A JOKE.. FOR A CHEAP TINY MOTOR NOT MUCH BIGGER THAN A MATCH BOX OVER A £100 SCRAP YARD £5 POUNDS...........HOPE THIS WILL BE OF SOME HELP TO YOU...

Dec 13, 2008 | 2002 Audi A4

1 Answer

Windscreen demister


Have you taken the dash apart and checked the cable on the switch? Or tested the switch if it's electronic?

Sep 29, 2008 | 1999 Daewoo Lanos

Not finding what you are looking for?
1999 Hyundai Accent Logo

134 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...