Question about 1994 Buick Park Avenue

1 Answer

Low coolaint light stays on

Coolaint level full

Posted by on

  • GeorgePA1994 Feb 08, 2009

    I have the same problem, tried another sensor from other Park Avenue, but light still stays on even with this correctly working sensor. Any idea appreciated

  • Anonymous Mar 22, 2014

    Coolaint leak will stop when car is off replaced resavor

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 67 Answers

Look on the sides of the radiator for some wires going to the sensor. reseat wires, otherwise the coolant sensor is bad.

Posted on Jan 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Low coolant level light on


Check that the wiring and terminals to the sender unit are not broken or dirty. If they are good maybe the sender unit it self is not working.

Jun 07, 2015 | 1985 Jaguar XJ6

1 Answer

Why is my1997 chevy lumina low coolant light is on and the radiator is full of coolant ?


In most newer chevys, the coolant reservoir is part of the pressurized system. Rather than just holding overflow coolant and relying on the radiator pressure cap to draw from and expel to the reservoir, it is an active part of the cooling system. On these systems, there is a coolant level switch in the reservoir. This will activate if the level in the reservoir gets below a certain point. So it is possible to have a full radiator and still get a low coolant light. Be advised that as the reservoir ages and get stained, it is not uncommon for the low coolant sensor to give false indications of low coolant.

Sep 06, 2014 | 1997 Chevrolet Lumina

2 Answers

I was low on oil. The warning lights came on and I immediatley pulled over and put a quart in. The light stayed on so I put in another quart. After looking at the dip stick I saw that I must have been...


first I would put in the proper amount of oil, once you are sure the level is full and if the light still comes on, pull the wire from the oil pressure sending unit, the light should go off with key on, if the light goes off then the sensor is bad. replace sensor

May 17, 2011 | 1996 Pontiac Grand Am

1 Answer

Low washer fluid light stays on


Either the resivoir is low of fluid or the sensor is stuck down or defective. Inspect the fluid level sensor.

Jan 03, 2011 | 2005 Chevrolet Malibu

2 Answers

Low coolant light stays on, coolant level is full


Check coolant level sensor, sit in the coolant resv. tank has two wire that go to it, tap on tank see if light goes off, if it don't replace sensor easy to do, part run's about $12.00 - $20.00, part # FLS609 at NAPA. Hope this was helpful.

Dec 11, 2009 | 1996 Chevrolet Cavalier

1 Answer

Low coolant light staying on


if the coolant is full you need to check and most likly change the low level sensor in the coolant tank.

Jun 11, 2009 | 2000 Ford Taurus

2 Answers

Why would the engine coolant leak out from under the engine versus at the radiator?


It can come from any of the rubber hoses that link from engine to heater core or a non properly installed hose or the water pump.

Jun 06, 2009 | 1997 Oldsmobile Achieva

Not finding what you are looking for?
1994 Buick Park Avenue Logo

Related Topics:

90 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...