Question about 2002 Chevrolet Corvette

1 Answer

Changing fog lamp in 2002 corvette

I'm wondering how to access and change the factory option fog lamps on a 2002 'Vette.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 840 Answers

You need to take off the lower splash sheilds on bumper they are retainer or bolted 10mm or retainers just pull the center and then pull out/ Please rate my response thank you very much

Posted on Jan 31, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace bulb on fog lamps suzuki xl7 2003


this info is in the operators guide, lost that? in the glove box.
my 07 manual shows no fog , lamp instructions
it says contact dealer and as you know they are DOA. Chapter 11.
any mech can do this..
some fogs are optional added lamps to some years, and makes and in some countries (not stated)
but in general its 3 ways.
Look at the lamp , see it?
does the front have screws on the lens. , remove it.
if not its a rear access lamp
gain access to the rear and remove the socket, and replace the lamp,
if all this is too hard, and still a wana DIY,
you could go to alldata.com and read how. under lighting,.
or post a photo of said fog lamp.. my 04 has no such lamp. BTW.
if the lamp need body panel removal. then in the FSM (or above link) you'd read the section under body. for how todo that.

Oct 17, 2013 | 2002 Suzuki XL-7

1 Answer

I purchased a used 2008 Jeep Patriot and it didn't come with fog lights. I have purchased OEM fog lights but I am having a hard time finding the connector plug to with them. Suggestion?


I have not run into this problem before. Usually, people either purchase the vehicle equipped with fog lamps from the factory or they add aftermarket fog lamps to the vehicle after purchase. In your case, you are trying to connect factory lamps that were not there from the factory? I'm not sure that you will find the connectors you are looking for. I do know for certain that the factory fog lamps are computer-controlled and that if the vehicle was not equipped with them from the factory, then the computer will not be programmed to make them work. If the wiring and connectors are there at all, they will be coming from the Totally Integrated Power Module (TIPM) located on the left fender. The factory wires are WHITE/YELLOW for the left fog lamp and WHITE/ORANGE for the right fog lamp. What about control switches,wire, etc. Did you purchase all of that as well?

Apr 24, 2011 | Jeep Patriot Cars & Trucks

1 Answer

Can't get my fog lamps to come on front. rear do


PULL OUT THE HEADLIGHT BUTTON ONCE IF NOT WORK CHANGE FRONT FOG LIGHTS

Apr 09, 2010 | 2003 Jaguar X-Type

1 Answer

How to replace fog light bulb on an '03 Jeep


There is a small square "trap door" in each wheel well directly behind the fog lamps. You can pry it open and access the fog lamps. They just twist loose.

Feb 11, 2010 | 2003 Jeep Wrangler

1 Answer

How do I replace the Drivers side fog lamp (not just bulb) on my 2002 Audi A4 18T?


First remove the driver's side fog lamp plastic cover out from front bumper. After that you will find torx socket head panel screws from fog lamp. See picture below:

de0b0fe.png

Feb 06, 2010 | 2002 Audi A4

1 Answer

Fog lights do not come on either when using headlights or with the fog lamp switch in my 2002 Grand Am SE. Fuse seems to be fine.


REPLACE THE FOG LAMP SWITCH DOWN ON THE STEERING COLM. REMOVE THE PROTEC. PANEL UNDER STEERING COLM. AND GENTLY START TO LOWER THE COLM. WATCH OUT FOR THE SHIFT IND. WIRE- REMOVE IT- LOWER COLM. AND HALF WAH DOWN ON THE TOP SIDE IS THE SWITCH FOR THE FOG LAMP CONTROL IF YOU HAVE ALREADY REPLACED THE ELEC. SWITCH - (PUSH BUTTON OR ROCKER STYLE ).IN THE DASH. IF - - LIGHTS AREON AND THE FOG LAMPS ARE TURNED ON AND THE HEAD LIGHT GO OUT OR WONT CHANGE FROM DIM TO BRIGHT REPLACE HIGH/LOW SWITCH ON COLM. SAME PROCEDURE AS FOG CONTOL SWITCH.

Nov 05, 2009 | Pontiac Grand Am Cars & Trucks

1 Answer

How to factory wire fog lights on a 2000 ford f150. pig tail, relay, and fuse are there. Only no wiring from fuse box.


This is a common problem on 97-00 MY trucks, regardless of the trim level ( XL, XLT, Lariat ).

If you install the fog lamp fuse in the BJB ( aka Battery Junction Box, Engine Compartment fuse panel ) Fuse # 9 ( 15 A fuse ) and jumper the normally open contacts in the fog lamp relay socket ( see diagram below ) the fog lamps should illuminate ( to confirm what you have doing on ).
8491ddd.jpg
The problem usually is the main headlamp switch to the BJB is not in place ( this is the yellow wire from the main headlamp switch connector to the relay socket pin #1 ).
One easy route is to make an aux lighting relay & harness, or purchase one online. With this, you can cut the factory ends and attach them to the harness you purchased. There is an air inlet next to where the steering wheel column runs through the firewall. This would give you an easy route to the fog lamp switch. The fog lamp switch, you can buy the factory one, and change the yellow wire from the connector to your added relay, or just add a switch for this function.
This will give you an idea of what the DIY relay and harness would look like.
5954a15.jpg

Hope this helps, more than confuses at this point

Sep 16, 2009 | 2000 Ford F150 Flareside SuperCab

1 Answer

How do I change the buld on my fog light?


Jeep WJ 1999-2003 - Front Foglamp (#9055)

1379890.jpg

The foglamp bulbs can be accessed and removed from underneath the bumper without tools, although it is a tight fit. Turn the lamp socket 1/4 turn counter-clockwise to remove from the rear of the housing. Note that the screw in the front of the foglamps is for alignment only and does not remove the outer lens. The fog lamp housing is attached to the fascia with two nuts which can be removed with a 10mm socket.

Fog lamps can be added to most Laredo model WJ's that came from the factory without them. Mopar kits are available that include two fog lights, wiring harness, and steering column switch. Click HERE for part numbers and other information on these kits.


Jeep WJ 2004 - Front Foglamp (#9145)


fc74409.jpg


Good luck (rated this help).

Sep 10, 2009 | 2004 Jeep Grand Cherokee

1 Answer

How to replace a fog lamp with replacement bulb only on 2002 toyota 4runner sport edition???? the three screws on the bottom?


Well, these are the steps and I will post the pic here in a second...looks like 2 screws...but like I said, you can see the picture for direction on this.


Remove or disconnect the following:

Front turn signal lamp
  • Connector
  • 2 screws
  • 2 claw fittings
  • Fog lamp assembly
  • Fog lamp bulb as shown
  • Fog light unit

  • To Install
    1. Install or connect the following:
      • Fog light unit
      • Fog lamp bulb as shown
      • Fog lamp assembly latch the 2 claw fittings and 2 screws
      • Connector
      • Front turn signal lamp
    Trying to post the pics now....

    May 14, 2009 | 2002 Toyota 4Runner

    2 Answers

    Hhr fog lights


    yes it is you will probably have to have the bcm programmed for the foglight option if your gonna install like factory is

    Sep 22, 2008 | 2007 Chevrolet HHR Special Edition

    Not finding what you are looking for?
    2002 Chevrolet Corvette Logo

    Related Topics:

    97 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Chevrolet Experts

    yadayada
    yadayada

    Level 3 Expert

    77499 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22306 Answers

    Ronny Bennett Sr.
    Ronny Bennett Sr.

    Level 3 Expert

    6927 Answers

    Are you a Chevrolet Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...